Operations and Maintenance Manual

_
JANUS
®
Multi-Protocol Reader Ver. 2: Maintenance Instructions
Confidential UM 360463-202: A12 (Draft) Page 239 of 291
© Kapsch TrafficCom Canada Inc. 2013
These drawings and specifications contain confidential and proprietary information and are the property of Kapsch TrafficCom Canada Inc. and are issued in strict
confidence and will be kept confidential and used solely for the purpose intended and for no other purpose and shall not be transmitted, reproduced, copied, and/or
used as the basis for manufacture or sale of apparatus unless otherwise agreed to in writing by Kapsch TrafficCom Canada Inc.
FILE: MPR2_OPERATIONS_AND_MAINTENANCE-MANUAL_REV A12.DOCX 05/08/2014 11:24
Kapsch TrafficCom
CAUTION:
On a redundant Reader, ensure that the redundant side has no
fault conditions and all lane controller links are functioning
1. Select the Manage Software link from the left panel of the screen.
Result: The following Software Update page appears.
Note: Ensure that the new firmware version is more recent than the active firmware version
2. Check the Space remaining to ensure there is enough Reader memory to load the new firmware.
3. If there is not enough Reader memory, delete an older, inactive version of the firmware (see Deleting
firmware, page 242).
4. Click the Browse button to select the new firmware file saved on the computer.
5. Click the Upload and Verify Software Update button, then click Yes to confirm.
Result: The firmware will upload from the computer to the Reader. After the firmware has finished
uploading to the Reader, the firmware appears in the table of available firmware versions as INACTIVE.
To begin using the new firmware, activate the firmware (see Activating new firmware).