Operations and Maintenance Manual

_
JANUS
®
Multi-Protocol Reader Ver. 2: Maintenance Instructions
Confidential UM 360463-202: A12 (Draft) Page 242 of 291
© Kapsch TrafficCom Canada Inc. 2013
These drawings and specifications contain confidential and proprietary information and are the property of Kapsch TrafficCom Canada Inc. and are issued in strict
confidence and will be kept confidential and used solely for the purpose intended and for no other purpose and shall not be transmitted, reproduced, copied, and/or
used as the basis for manufacture or sale of apparatus unless otherwise agreed to in writing by Kapsch TrafficCom Canada Inc.
FILE: MPR2_OPERATIONS_AND_MAINTENANCE-MANUAL_REV A12.DOCX 05/08/2014 11:24
Kapsch TrafficCom
On the Secondary side:
1. Repeat steps 1 through 4 for the secondary side, ensuring the same firmware version is active for the
primary and secondary side.
Deleting firmware
The Factory firmware and active firmware cannot be deleted. All callouts refer to Figure 7-3. This
procedure outlines the steps for deleting an inactive firmware version stored on the Reader.
Prerequisites: You must have Software Management permissions.
1. From the Software Management page, identify the inactive firmware version to be deleted in the
firmware version table ().
2. Click the corresponding Delete button (). Click Yes to confirm. The firmware will be deleted and will no
longer appear in the firmware version table ().
Figure 7-3: Deleting firmware