Operations and Maintenance Manual

_
JANUS
®
Multi-Protocol Reader Ver. 2: Maintenance Instructions
Confidential UM 360463-202: A12 (Draft) Page 247 of 291
© Kapsch TrafficCom Canada Inc. 2013
These drawings and specifications contain confidential and proprietary information and are the property of Kapsch TrafficCom Canada Inc. and are issued in strict
confidence and will be kept confidential and used solely for the purpose intended and for no other purpose and shall not be transmitted, reproduced, copied, and/or
used as the basis for manufacture or sale of apparatus unless otherwise agreed to in writing by Kapsch TrafficCom Canada Inc.
FILE: MPR2_OPERATIONS_AND_MAINTENANCE-MANUAL_REV A12.DOCX 05/08/2014 11:24
Kapsch TrafficCom
Figure 7-4: The Manage Config tab on the Configuration page
Resetting the Reader configuration to the factory default
Certain field service tests use the factory default configuration. This procedure outlines how to restore
the factory default values without changing the Reader IP addresses.
Prerequisites: A service laptop connected to Ethernet 1 or a USB port of the CTM and accessing the
CTM web interface. Refer to Connecting a service laptop to the Reader, page 40. Save the current
Reader configuration (Saving the Reader configuration, page 243).
CAUTION:
The factory default configuration should not be restored on a
running Reader. The factory firmware may not be appropriate for
the specific application. Save the current Reader configuration
before resetting the Reader configuration to the factory default.
1. Click on the Configuration link on the left side panel of the CTM web Interface.
Result: The following Configuration page appears.