Operations and Maintenance Manual

ManualsBrandsKAPSCH TRAFFICCOM CANADA ManualsElectronicsNon-multilateration LMS transmitter and receiver

JANUS

Multi-Protocol Reader Ver. 2: Operating Instructions

Confidential UM 360463-202 Revision: A12 (Draft) Page 25 of 291

These drawings and specifications contain confidential and proprietary information and are the property of Kapsch TrafficCom Canada Inc. and are issued in strict

confidence and will be kept confidential and used solely for the purpose intended and for no other purpose and shall not be transmitted, reproduced, copied, and/or

used as the basis for manufacture or sale of apparatus unless otherwise agreed to in writing by Kapsch TrafficCom Canada Inc.

FILE: MPR2_OPERATIONS_AND_MAINTENANCE-MANUAL_REV A12.DOCX 05/08/2014 11:24

Kapsch TrafficCom

The Reader consists of:

Note: Numbers in the list below refer to those associated with Figure 2-1: A Redundant Reader. The

DSM, and CFM are not shown in the figure.

 One rack and Distribution Module

 Two Controller Modules (CTM), each equipped with one Main Controller (MC),

one Channel Group Controller (CGC)

 Two Configuration Modules (CFMs) attach directly to the DSM

 One Synchronization Port Module (SPM)

 Two Lane Port Modules (LPM)

 One secondary Power Supply Module (PSM) and AC power cord

 One primary Power Supply Module (PSM) and AC Power Cord

 AC Power cords for the PSM’s

Note: Non-redundant Readers contain one CTM, one CFM, one LPM, and one PSM. For an illustration

of a non-redundant reader, see Appendix B.

Additional installation components required are:

 Two RF cables from Reader to Circulator (type N male to type N female)

 Sealing tapes for RF and DC connectors exposed to weather

 Lightning arrestors

 Optional Ethernet switch modules (ESMs)

 Sync and inter-reader Ethernet cabling (if required)

 Ethernet cables if ESMs used

 300 CFM fan tray for operation above 55

Additional Site requirements are:

 Cabinet with AC power, grounding, including reader ground bar,

 Mounting structure for antenna

 Ethernet or Serial cables to connect to the lane Controller(s)