Operations and Maintenance Manual

ManualsBrandsKAPSCH TRAFFICCOM CANADA ManualsElectronicsNon-multilateration LMS transmitter and receiver

Confidential UM 360463-202 Revision: A12 (Draft) Page 3 of 291

These drawings and specifications contain confidential and proprietary information and are the property of Kapsch TrafficCom Canada Inc. and are issued in strict

confidence and will be kept confidential and used solely for the purpose intended and for no other purpose and shall not be transmitted, reproduced, copied, and/or

used as the basis for manufacture or sale of apparatus unless otherwise agreed to in writing by Kapsch TrafficCom Canada Inc.

FILE: MPR2_OPERATIONS_AND_MAINTENANCE-MANUAL_REV A12.DOCX 05/08/2014 11:24

Kapsch TrafficCom

FCC License Notice:

This equipment emits RF signals. In order to operate this equipment the customer

must obtain a separate FCC Part 90 Site license for each location. In addition, the

FCC ID component identification JQU802295 must appear on a label on the front

of the RF Modules installed in these Readers.

NOTE: This device complies with Part 15 of the FCC Rules. Operation is subject to

the following two conditions: (1) this device may not cause harmful interference

and (2) this device must accept any interference received, including interference

that may cause undesired operation.

NOTE: This equipment has been tested and found to comply with the limits for a

Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are

designed to provide reasonable protection against harmful interference when the

equipment is operated in a commercial environment. This equipment generates,

uses, and can radiate radio frequency energy and, if not installed and used in

accordance with the instruction manual, may cause harmful interference to radio

communications. Operation of this equipment in a residential area is likely to

cause harmful interference in which case the user will be required to correct the

interference at their expense.

Changes or modifications not expressly approved by Kapsch TrafficCom could

void FCC compliance and the authority to operate the equipment.

The Power output of a module at ambient (Pout(amb)) shall be constrained using

internal or external TX attenuation so that the following is satisfied:

Pout(amb): Gfund <= 43.77 dBmd - Gfund;

Where Gfund is the net gain from antenna connector on the RF module to the

antenna radiated signal where the antenna gain is expressed in dBd.

NOTE: IEC 60950-1 and/or EN60950-1, First Edition, Information Technology

Equipment – Safety – Part 1: General Requirements require that this equipment

must be located in a RESTRICTED ACCESS LOCATION (RAL). Only authorized

personnel can have access to the equipment.