Operations and Maintenance Manual

ManualsBrandsKAPSCH TRAFFICCOM CANADA ManualsElectronicsNon-multilateration LMS transmitter and receiver

JANUS

Multi-Protocol Reader Ver. 2: Operating Instructions

Confidential UM 360463-202 Revision: A12 (Draft) Page 40 of 291

These drawings and specifications contain confidential and proprietary information and are the property of Kapsch TrafficCom Canada Inc. and are issued in strict

confidence and will be kept confidential and used solely for the purpose intended and for no other purpose and shall not be transmitted, reproduced, copied, and/or

used as the basis for manufacture or sale of apparatus unless otherwise agreed to in writing by Kapsch TrafficCom Canada Inc.

FILE: MPR2_OPERATIONS_AND_MAINTENANCE-MANUAL_REV A12.DOCX 05/08/2014 11:24

Kapsch TrafficCom

1. Set both CTM ON/OFF switches to OFF.

2. Set both PSM power switches to the off (0) position.

Manually switching a Reader to the redundant side

The Reader is manually switched between the primary and secondary sides. This is necessary, for

example, when recovering a Reader back to the Primary side when automatic recovery is not enabled.

Prerequisites: Ensure no faults exist on the side being activated.

1. Set the SPM redundancy mode switch to either SECONDARY or PRIMARY, as applicable.

Result: The ACTIVE LED on the CTM of the selected side illuminates green, indicating the selected side

is active.

Note: If the redundancy mode switch is set to PRIMARY, the Reader stays in Primary mode and does not

switch operation to the secondary side unless the primary side fails.

Note: If the switch is set to SECONDARY, the Reader stays in Secondary mode and does not switch

operation to the primary side unless the secondary side fails or the primary side recovers.

Connecting a service laptop to the Reader

You can use a service laptop to access the CTM web interface interface by connecting directly to one

of the CTM USB ports or the ETHERNET 1 port.

Changing the service laptop IP address

1. In Windows, go to Start  Settings Control Panel  Network Connections  Local Area Connection 

Properties  Internet Protocol (TCP/IP)  Properties.

2. Select Use the following IP address, then enter the IP address using the Reader network number in the

first three fields (ex. 192.168.1._ ) followed by a unique host number in the fourth field.

3. Enter 225.225.225.0 in the subnet mask and leave the default gateway blank.

Testing the connection to the reader

1. In Windows, go to Start  Run.

2. Type ‘ping’, followed by the ETHERNET 1 port IP address or the USB adapter address, depending on

what the laptop is connected.

3. Click OK.

Result: Several replies from the Reader IP address display momentarily in a DOS window. You are

ready to access the CTM web interface (see Accessing the CTM web interface page 41).

Note: If a reply is not received during the test, check the cable, connections, and IP addresses, then

repeat step 1.