Operations and Maintenance Manual

ManualsBrandsKAPSCH TRAFFICCOM CANADA ManualsElectronicsNon-multilateration LMS transmitter and receiver

JANUS

Multi-Protocol Reader Ver. 2: Operating Instructions

Confidential UM 360463-202 Revision: A12 (Draft) Page 45 of 291

These drawings and specifications contain confidential and proprietary information and are the property of Kapsch TrafficCom Canada Inc. and are issued in strict

confidence and will be kept confidential and used solely for the purpose intended and for no other purpose and shall not be transmitted, reproduced, copied, and/or

used as the basis for manufacture or sale of apparatus unless otherwise agreed to in writing by Kapsch TrafficCom Canada Inc.

FILE: MPR2_OPERATIONS_AND_MAINTENANCE-MANUAL_REV A12.DOCX 05/08/2014 11:24

Kapsch TrafficCom

Prerequisites: The user clearing the password must have User Admin permissions.

Note: The User Administrator should ensure that the user sets a new password after the password is

cleared. Otherwise, the Reader will continue to accept any password for that user account.

1. Navigate to the User Management tab on the User Management page.

2. Use the following decision table to continue the procedure.

IF you logged into an account that …

THEN …

has User Admin permissions,

go to step 3 and continue to step 5.

does NOT have User Admin permissions,

go to step 6 and continue to step 8.

3. Click the corresponding Clear Password button of the user whose password needs resetting.

4. Click Yes to confirm.

5. Log out (see Logging out of the CTM web interface, page 44).

6. Select Change Password from the navigation sidebar.

7. Enter your user name and compose a password.

Note: This password does not become your new password.

8. Change your password (see Changing your password on page 44).

Result: Your password resets.

Configuring the Reader to recover automatically to the primary side

The Reader can be configured to automatically activate the primary side once a failure causing a

switchover to the secondary side has cleared.

Prerequisites: Connect the service laptop to the Reader configuration port to access the CTM web

interface. Refer to Connecting a service laptop to the Reader, page 40.

Note: You must have Advanced User permissions.

1. Set the SPM redundancy mode switch to the AUTO position.

2. From the CTM web Main Page, select the Configuration link on the left panel of the screen.

Result: The following Configuration page appears.