Operations and Maintenance Manual

_
JANUS
®
Multi-Protocol Reader Ver. 2: Operating Instructions
Confidential UM 360463-202 Revision: A12 (Draft) Page 63 of 291
© Kapsch TrafficCom Canada Inc. 2014
These drawings and specifications contain confidential and proprietary information and are the property of Kapsch TrafficCom Canada Inc. and are issued in strict
confidence and will be kept confidential and used solely for the purpose intended and for no other purpose and shall not be transmitted, reproduced, copied, and/or
used as the basis for manufacture or sale of apparatus unless otherwise agreed to in writing by Kapsch TrafficCom Canada Inc.
FILE: MPR2_OPERATIONS_AND_MAINTENANCE-MANUAL_REV A12.DOCX 05/08/2014 11:24
Kapsch TrafficCom
Note: The USB Logging changes its display from Disabled to Enabled, and USB Device Status remains
at Available to indicate that a connection between the Reader and the USB flash drive and log files can
get copied and updated to the USB device in realtime when required.
Note: You can click the Copy Log Files to USB device button if you just want to copy the present list of
log files to the USB device.
OBU Programming
The Reader can write data to an OBU as it passes through a toll plaza. The following procedures
outline how to enable OBU programming and how to configure the data that is written to the OBUs.
Prerequisites: Connect the service laptop to the Reader configuration port to access the CTM web
interface. Refer to Connecting a service laptop to the Reader, page 40.
1. Select the Configuration link on the left side panel of the screen.
Result: The following screen appears.
2. Click the Tag Programming tab.
Result: The following screen appears.