Operations and Maintenance Manual

ManualsBrandsKAPSCH TRAFFICCOM CANADA ManualsElectronicsNon-multilateration LMS transmitter and receiver

JANUS

Multi-Protocol Reader Ver. 2: Operating Instructions

Confidential UM 360463-202 Revision: A12 (Draft) Page 71 of 291

These drawings and specifications contain confidential and proprietary information and are the property of Kapsch TrafficCom Canada Inc. and are issued in strict

confidence and will be kept confidential and used solely for the purpose intended and for no other purpose and shall not be transmitted, reproduced, copied, and/or

used as the basis for manufacture or sale of apparatus unless otherwise agreed to in writing by Kapsch TrafficCom Canada Inc.

FILE: MPR2_OPERATIONS_AND_MAINTENANCE-MANUAL_REV A12.DOCX 05/08/2014 11:24

Kapsch TrafficCom

2. When the reader leaves the factory, only those protocols selected by the customer are available for

configuration. All other protocols will be de-selected.

3. Select each channel and use the TDM RF State and FDM RF State to enable or disable a channel.

4. Select the frequency for each channel by using the FDM Frequency (MHZ) selection.

Note: This should only be performed with Kapsch technical support.

5. Select the specific combination of protocols desired.

Note: This should only be performed with Kapsch Technical Support.