Operations and Maintenance Manual

ManualsBrandsKAPSCH TRAFFICCOM CANADA ManualsElectronicsNon-multilateration LMS transmitter and receiver

JANUS

Multi-Protocol Reader Ver. 2: Operating Instructions

Confidential UM 360463-202: A12 (Draft) Page 80 of 291

These drawings and specifications contain confidential and proprietary information and are the property of Kapsch TrafficCom Canada Inc. and are issued in strict confidence and will be kept confidential and used solely for the purpose

intended and for no other purpose and shall not be transmitted, reproduced, copied, and/or used as the basis for manufacture or sale of apparatus unless otherwise agreed to in writing by Kapsch TrafficCom Canada Inc.

FILE: MPR2_OPERATIONS_AND_MAINTENANCE-MANUAL_REV A12.DOCX 05/08/2014 11:24

Kapsch TrafficCom

Command

How is this command

executed?

Who can

execute this

command?

Parameter

Name

Default

Parameter

Value

Parameter

Range/Options

What does this

command do?

What is the

purpose of this

command?

Diagnostics

Port Baud Rate

From the General tab on the

Configuration page:

Select a baud rate from the

Diagnostics Port Baud Rate

drop-down box, then, , click

outside the field, press Enter,

or select a different tab.

anyone

DIAGBD

0 (9600)

1 (19200)

2 (38400)

3 (57600)

4 (115200)

sets baud rate of

DIAGNOSTICS PORT on

the CTM

Used to establish

a baud rate for

connecting a

service laptop

computer to the

Reader via the

CTM

DIAGNOSTICS

PORT

Reader Sync:

Enable Reader

Sync

From the General tab on the

Configuration page:

Select the Enable Reader Sync

check box, then, , click outside

the field, press Enter, or select

a different tab.

anyone

RFSYNC

0 (Disabled)

1 (Enabled)

Disabled: Reader RF

interrogation is not

synchronized with other

Readers

Enabled: Reader RF

interrogation is

synchronized with other

Readers in the sync

network

Used to

synchronize

superframes

between

Readers

connected

together in a

synchronization

network