Operations and Maintenance Manual

_
JANUS
®
Multi-Protocol Reader Ver. 2: Operating Instructions
Confidential UM 360463-202: A12 (Draft) Page 85 of 291
© Kapsch TrafficCom Canada Inc. 2014
These drawings and specifications contain confidential and proprietary information and are the property of Kapsch TrafficCom Canada Inc. and are issued in strict confidence and will be kept confidential and used solely for the purpose
intended and for no other purpose and shall not be transmitted, reproduced, copied, and/or used as the basis for manufacture or sale of apparatus unless otherwise agreed to in writing by Kapsch TrafficCom Canada Inc.
FILE: MPR2_OPERATIONS_AND_MAINTENANCE-MANUAL_REV A12.DOCX 05/08/2014 11:24
Kapsch TrafficCom
Command
How is this command
executed?
Who can
execute this
command?
Parameter
Name
Default
Parameter
Value
Parameter
Range/Options
What does this
command do?
What is the
purpose of this
command?
6 - HOT Tag
Delay [ms]
From the General tab on the
Configuration page:
Enter a time (in milliseconds) in
the HOT Tag Delay field, then, ,
click outside the field, press
Enter, or select a different tab.
user with
Advanced
User
permissions
LYCTL6
0
0-5000
sets report delay time in
milliseconds for CVO
OBUs (Type 6).
Used to slow
down the
transaction
report of Type 6
OBUs to the LC
for those legacy
sites where the
LC is expecting
BADGER Reader
timing
Primary/Secondary
Redundant
Mode
From the General tab on the
Configuration page:
Select the Redundant Mode
check box, then, , click outside
the field, press Enter, or select
a different tab.
user with
Advanced
User
permissions
RDNDNT
1 (Redundant
Mode
enabled)
0 (Disabled)
1 (Enabled)
Disabled: Reader does not
attempt to switch to
redundant side when a
failure occurs.
Enabled: Reader attempts
to switch to redundant
side when a failure occurs
(depending on
configuration)
Used to enable
the Reader to
automatically
switch over to
the redundant
side when a
failure occurs