Operations and Maintenance Manual

_
JANUS
®
Multi-Protocol Reader Ver. 2: Operating Instructions
Confidential UM 360463-202: A12 (Draft) Page 93 of 291
© Kapsch TrafficCom Canada Inc. 2014
These drawings and specifications contain confidential and proprietary information and are the property of Kapsch TrafficCom Canada Inc. and are issued in strict confidence and will be kept confidential and used solely for the purpose
intended and for no other purpose and shall not be transmitted, reproduced, copied, and/or used as the basis for manufacture or sale of apparatus unless otherwise agreed to in writing by Kapsch TrafficCom Canada Inc.
FILE: MPR2_OPERATIONS_AND_MAINTENANCE-MANUAL_REV A12.DOCX 05/08/2014 11:24
Kapsch TrafficCom
Command
How is this command
executed?
Who can
execute this
command?
Parameter
Name
Default
Parameter
Value
Parameter
Range/Options
What does this
command do?
What is the
purpose of this
command?
Enable Right
Reader
From the Lane Assignment tab
on the Configuration page,
with Ethernet communication
method enabled:
Select the Enable Right Reader
check box, then, press Enter or
select a different tab.
user with
Advanced
User
permissions
RGHTRD
0 (Disabled)
0 (Disabled)
1 (Enabled)
Disabled: Reader does not
coordinate voting with
Reader covering lanes to
the right.
Enabled: Reader
coordinated lane
assignment voting with
Reader covering lanes to
the right.
tells this Reader
if there is
another Reader
in the IR network
that is covering
ORT lanes that
are to the right
of the lanes this
Reader is
covering
(see Figure 5-13,
page 175)
Right Reader IP
From the Lane Assignment tab
on the Configuration page,
with the Right Reader enabled,
Enter the IP address of the
right Reader in the Right
Reader IP field, then, press
Enter or select a different tab.
user with
Advanced
User
permissions
RGHTIP
0,0,0,0,50
N/A
informs the Reader what
the IP address is of the
Reader covering lanes to
the right of this Reader.
to provide the
Reader with the
IP address of the
right Reader in
the IR network
(see Figure 5-13,
page 175)
Tag Programming tab
Read-Only
Mode
(enabled)
From the Tag Programming tab
on the Configuration page:
Select the Read-Only Mode
check box.
anyone
RDONLY
0 (Disabled)
0 (Disabled)
1 (Enabled)
Disabled: Reader is able
to write to OBUs.
Enabled: Reader is not
permitted to write to
OBUs.
to disable the
ability to write
data to OBUs