Operations and Maintenance Manual

_
JANUS
®
Multi-Protocol Reader Ver. 2: Operating Instructions
Confidential UM 360450-210 Revision C Page 122 of 288
© Kapsch TrafficCom Canada Inc. 2014
These drawings and specifications contain confidential and proprietary information and are the property of Kapsch TrafficCom Canada Inc. and are issued in strict confidence and will be kept confidential and used solely for the purpose
intended and for no other purpose and shall not be transmitted, reproduced, copied, and/or used as the basis for manufacture or sale of apparatus unless otherwise agreed to in writing by Kapsch TrafficCom Canada Inc.
FILE: UM 360450-210 REV C JANUS MPR2 OPERATOR-MAINTENANCE MANUAL.DOCX 08/17/2015 11:42
Kapsch TrafficCom
Command
How is this command
executed?
Who can
execute this
command?
Parameter
Name
Default
Parameter
Value
Parameter
Range/Options
What does this
command do?
What is the
purpose of this
command?
TDM RF State
From the Channel tab
on the Configuration
page:
Select one of the
choices offered from
the drop down menu
for every appropriate
channel.
anyone
RF_STS
0 (Offline)
0 (Offline)
1 Active
2 Guard
3 Skip
Offline means the MRFM-
S module is off.
Active means the MRFM-S
module is on and reports
transactions on this channel.
Guard means MRFM-S
module is on, but
transactions assigned to
this channel are not
reported.
Skip controls the scanning
rate and should be used
only for channels 5 or
higher.
Used for IAG,
Allegro
protocols,
TDM Tag Protocol
From the Channel tab
on the Configuration
page:
Select one or both of
the checkboxes for
every appropriate
channel.
anyone
TDMPRT
0
0-3
Specifies which TDM
protocols are to be
interrogated per channel.
Select any or none of the
following by adding selected
values together:
0x00000001 - IAG
0x00000002 - Allegro
Used for IAG,
Allegro
protocols,