Operations and Maintenance Manual

_
JANUS
®
Multi-Protocol Reader Ver. 2: Maintenance Instructions
Confidential UM 360450-210 Revision C Page 186 of 288
© Kapsch TrafficCom Canada Inc. 2014
These drawings and specifications contain confidential and proprietary information and are the property of Kapsch TrafficCom Canada Inc. and are issued in strict
confidence and will be kept confidential and used solely for the purpose intended and for no other purpose and shall not be transmitted, reproduced, copied, and/or
used as the basis for manufacture or sale of apparatus unless otherwise agreed to in writing by Kapsch TrafficCom Canada Inc.
FILE: UM 360450-210 REV C JANUS MPR2 OPERATOR-MAINTENANCE MANUAL.DOCX 08/17/2015 11:42
Kapsch TrafficCom
5. From the Serial Port dropdowns, select an LPM port for each RF channel to use to communicate with the
LC.
Note 1: By default, RF Channel 1 communicates with the LC via LPM COM 1, RF Channel 2 communicates
with the LC via LPM COM 2 and so on, up to RF Channel 8.
Note 2: More than one RF Channel can communicate via one LPM COM port, if necessary.
6. Click the Serial tab on the Configuration page.
Result: The following screen appears.
7. Ensure all the COM Ports selected in step 5 are enabled by selecting the corresponding Serial Port
State check box.
8. Select the Baud Rate, Data Bits, Parity, and Stop Bits to match the LC communication settings.
Example: An example of what your screen may look like follows.
Refer to the Configuring the Reader to switch over automatically when an LC link is down procedure on page 238
to configure the Reader to switch over when the connection from the LPM to the LC is down.
IP addresses
Each ethernet port in an IR or LC network must have a unique IP address. The IP addresses should be
set as required for the site network topology. Default IP addresses are:
 Primary and secondary Ethernet 1 port: 192.168.1.50