Operations and Maintenance Manual

_
JANUS
®
Multi-Protocol Reader Ver. 2: Appendix
Confidential UM 360450-210 Revision C Page 222 of 288
© Kapsch TrafficCom Canada Inc. 2014
These drawings and specifications contain confidential and proprietary information and are the property of Kapsch TrafficCom Canada Inc. and are issued in strict
confidence and will be kept confidential and used solely for the purpose intended and for no other purpose and shall not be transmitted, reproduced, copied, and/or
used as the basis for manufacture or sale of apparatus unless otherwise agreed to in writing by Kapsch TrafficCom Canada Inc.
FILE: UM 360450-210 REV C JANUS MPR2 OPERATOR-MAINTENANCE MANUAL.DOCX 08/17/2015 11:42
Kapsch TrafficCom
Note: If a Kapsch TrafficCom maintenance agreement is in place, the CTM needing a new battery can be
replaced by a spare CTM. The CTM is then sent to Kapsch Service to have its battery replaced.
MRFM-S replacement
The Reader does not need to be shut down to replace an MRFM-S.
Prerequisites: Connect the service laptop to the Reader configuration port to access the CTM web
interface. Refer to Connecting a service laptop to the Reader, page 47.
WARNING:
THE MODULES MAY HAVE SHARP EDGES. HANDLE THE MODULES
CAREFULLY. WHENEVER POSSIBLE, USE A MODULE EXTRACTION TOOL
TO REMOVE A MODULE.
WARNING:
THE MRFM-S MAY BECOME HOT UNDER NORMAL OPERATING
CONDITIONS. ENSURE THE MRFM-S HAS COOLED DOWN OR WEAR
GLOVES WHEN HANDLING THE MRFM-S.
Removing an MRFM-S
1. Select the Configuration link on the left side panel of the CTM web interface.
2. Click the Channel tab.
Result: The following screen appears.