Operations and Maintenance Manual

ManualsBrandsKAPSCH TRAFFICCOM CANADA ManualsElectronicsNon-multilateral LMS transmitter and receiver

241

242

243

244

245

246

247

248

249

250

JANUS

Multi-Protocol Reader Ver. 2: Appendix

Confidential UM 360450-210 Revision C Page 247 of 288

These drawings and specifications contain confidential and proprietary information and are the property of Kapsch TrafficCom Canada Inc. and are issued in strict

confidence and will be kept confidential and used solely for the purpose intended and for no other purpose and shall not be transmitted, reproduced, copied, and/or

used as the basis for manufacture or sale of apparatus unless otherwise agreed to in writing by Kapsch TrafficCom Canada Inc.

FILE: UM 360450-210 REV C JANUS MPR2 OPERATOR-MAINTENANCE MANUAL.DOCX 08/17/2015 11:42

Kapsch TrafficCom

environment.

1. From the Manage Config tab on the Configuration page, click the Browse button to locate the

configuration file on the service laptop to be uploaded.

2. If uploading all configuration settings to the Reader without changing the IP addresses settings, click the

first Upload Config button.

3. If uploading all configuration settings to the Reader, including the IP addresses, click the second Upload

Config button.

Resetting the Reader configuration to the factory default

Certain field service tests use the factory default configuration. This procedure outlines how to restore

the factory default values without changing the Reader IP addresses.

Prerequisites: A service laptop connected to Ethernet 1 or a USB port of the CTM and accessing the

CTM web interface. Refer to Connecting a service laptop to the Reader, page 47. Save the current

Reader configuration (Saving the Reader configuration, page 246).

CAUTION:

The factory default configuration should not be restored on a

running Reader. The factory firmware may not be appropriate for

the specific application. Save the current Reader configuration

before resetting the Reader configuration to the factory default.

1. Click on the Configuration link on the left side panel of the CTM web Interface.

2. Click the Manage Config tab.

Result: The following screen appears.

3. Click the Reset Parameters to Default Values button.