Kapsch TrafficCom AG User Manual OMR WAVE-UNIT This device is based on the IEEE WAVE Standards 1000005542-Bed-02
Document number 1000005542 Document type Bed Document version 02 Document status released Date of release 2010-04-21 Valid from Software version - Created by: Batko Manfred Checked by: Povolny Robert Approved by: Komarica Anto Disclaimer and Limitation of Liability The products described in this manual are provided “as is” and without any warranties of any kind, either express or implied.
User Manual | OMR-WAVE-UNIT Page 3 of 15 Table of Contents Page Information about this document 5 Text conventions ............................................................................................. 5 Important text elements ................................................................................... 5 Abbreviations ...................................................................................................
User Manual | OMR-WAVE-UNIT Page 5 of 15 Information about this document Audience This document is for professionals setting up and maintaining the equipment. Professionals are persons, who have basic knowledge of software installation and computer equipment. Preparations This User Manual shall be carefully read before installation. Text conventions Visual aids and standard text formats in this manual help the reader to locate and identify information easily.
Page 6 of 15 User Manual | OMR WAVE-UNIT Abbreviations Table 1 Abbreviations and definitions DSRC Dedicated Short Range Communication OBU Onboard Unit (adjustable by user) RF Radio Frequency WAVE Wireless Access in Vehicular Environments 1000005542-Bed-02
Warning to users in the United States Page 7 of 15 Warning to users in the United States Local Regulations The hardware referred to in this document allows selection of frequency bands and transmit power levels that may not comply with the regulatory body that governs spectrum policy where the hardware is being used. Local Restrictions This equipment is certified under 47 CFR Part 90M as a portable RSU.
Page 8 of 15 User Manual | OMR WAVE-UNIT Regulatory Information Notice This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: Notice 1. This device may not cause harmful interference, and 2. This device must accept any interference interference that may cause undesired operation. received, including Changes or modifications made to this equipment not expressly approved by Kapsch may void the FCC authorization to operate this equipment.
Software Licenses Page 9 of 15 Software Licenses This product may contain software portions including technologies used under third party license, and are copyrighted. Notices, Terms and Conditions pertaining to third party software are located at http://www.kapsch.net/us/en/ktc/portfolio/products_and_components/Pa ges/default.aspx Safety Instructions Caution: During operation the WAVE-UNIT must not be held closer than 20cm (8 in) to the body and must not point to the body of another person.
Page 10 of 15 User Manual | OMR WAVE-UNIT General Information Definitions PDA The PDA is a handheld unit, which shall be used with the OMR-WAVEUNIT. It has to be compatible with the GOTIVE H42 device. WAVE UNIT The OMR-WAVE-UNIT is a module for the GOTIVE H42 and compatible devices, which is compliant to the WAVE standard.
Installation Page 11 of 15 Installation Mount the WAVE unit Adjust the lug of WAVE-UNIT in the appropriate slot the PDA and press the WAVE module down until it locks with the PDA. Check for correct fit. Remove the WAVE unit Press the button on the WAVE-UNIT and pull the WAVE-UNIT off. Charging The PDA can be charged without removing the WAVE-UNIT module. Plug in cable in jack on the side of the WAVE-UNIT. Warning: The WAVE-UNIT does not include any charging control mechanisms for the PDA.
Page 12 of 15 User Manual | OMR WAVE-UNIT Reading OBUs Re a g din Ra ng p eu 1 to e 0fe t( ) 3m The typical reading range is up to 3m (10feet) and depends on these parameters: OBU’s mounting angle on windshields Offset angle to bore sight between reader unit and OBU Note: When reading a specific OBU make sure that no other OBU’s are in the communication range of the reader to prevent reading the wrong OBU.
Product Specifications Page 13 of 15 Product Specifications Mechanical data 4in x 3in x 1.5in 108mmx 68mm x 37mm [LxWxH] Electrical data Environmental conditions USB powered device Power consumption (operating mode) max. 2.5W Temperature (operation) -10°C … +55°C 14°F … +131°F Storage temperature -30°C … +60°C -22°F … +140°F Ambient humidity Interface 5 to 95% non condensing USB 2.0 full speed USB powered device RF Interfaces Compliance Frequency range 5.850GHz - 5.
Page 14 of 15 User Manual | OMR WAVE-UNIT Conformity Standards Table 3 Standards Ref. Standard Description [1] ASTM E2213 - 03 Standard Specification for Telecommunications and Information Exchange Between Roadside and Vehicle Systems — 5 GHz Band Dedicated Short Range Communications (DSRC) Medium Access Control (MAC) and Physical Layer (PHY) Specifications [2] IEEE 802.
Conformity Address Page 15 of 15 For further information please contact: Kapsch TrafficCom U.S. Corp. 21515 Ridgetop Circle, Suite 290 Sterling, VA 20166 Phone: +1 (703) 885 1976 Kapsch TrafficCom AG Am Europlatz 2 A-1120 Vienna Phone: +43 (0)50 811 0 Fax: +43 (0)50 811 2589 E-mail: kapsch.at@kapsch.
