User's Manual

Page 60 of 105 User Manual | SRU-8X1X RFID Reader 18000-63
Doc No. 47000001740
|
Version 01
|
2018-12-11
|
released
Confidential
14.1.2.1 Selecting a Linux Module Option
1. Click on the symbol
ۆ The following options appear:
2. Click on one of the four options to change the settings
14.1.2.2 General
Figure 25 Communication configuration Linux model: general
ᬅ
Refresh reads the current settings of the communication configuration Linux module
ᬆ
Name
shows the host name of the reader which is logged onto the DNS server It is possible
to address the reader using this name as an alternative to the IP address.
ᬇ
Keep alive
time
specifies the intervals of time at which the reader sends a data packet to check
whether the receiver is still available
If the connection to the reader is broken, the reader shuts down the connection. If this
parameter is deactivated (0 ms), the socket is shut down only when the reader is
restarted.
If no keep-alive time is set, it may happen that the reader cannot
take up any further connections because the existing connections
have not been properly shut down, e.g. following a breakage in the
wire. In this case, it is necessary to restart the reader. It is
recommended to use the keep-alive time to check the connection
between the reader and PC.

Get reads the configured general settings

Set saves new general settings