Operation Manual

20 | EN

• Press the Volume +/- buttons to adjust the volume on the speaker. A beep tone will be heard

when the maximum or minimum volume is reached.

• Additionally you can set the volume and equalizer on your device in order to reach the

perfect sound.

Other Features

Reconnection Between Bluetooth

Device and BT 4160

You can reconnect your paired Bluetooth

device to your speaker easily:

• Select the BT 4160 entry on the Bluetooth

device to reconnect. Any of the 8 previously

connected Bluetooth

devices would be able to reconnect to BT 4160 when it is powered on

and not connected to any device.

Note:

BT 4160 is able to remember up to 8 paired devices in its memory bank, eliminating the need to

re-pair again should any of these devices connect to it. Should a 9th device be paired to BT 4160,

the rst device will be erased from its memory. At any time a maximum memory of 8 devices are

being retained.

Toggle Between the Last Two Connected Bluetooth

Devices

You can toggle between devices to enjoy your favorite music from another paired Bluetooth

device

by following these steps to establish connection:

1. Press the CONNECT button once.

2. LED status indicator goes off and blinks at every 2 second intervall.

3. Ready to stream music.

Notes:

• Ensure that your next paired device’s Bluetooth

feature is on and ready to accept connec-

tions.

• While switching from one device to another, short dropouts in the playback may occur. After

a few seconds playback should reutrn to normal.

Hands Free Function

When you receive a phone call on the connected device while listening to music via BT 4160 you

will hear a ringing. To answer the call, press the CONNECT button once. You will now hear the

caller‘s voice on the speaker. To end the call and return to the music playback, press the CON-

NECT button once again.

If you start a phone call from your connected device, the audio will be streamed over the speaker.

Return to Default Setting

You can return BT 4160 to its default settings and erase its memory of paired devices by following

these steps: