Operation Manual

EN - 17

Power Supply

Power Adaptor

1. The unit requires DC 5V 1.2A.

2. Plug the supplied adaptor cable into the DC input socket of the unit and the other end

into a suitable wall socket.

3. Make sure that the output power of the wall outlet matches the required power of the

adaptor.

Note:

• If not using the unit for a longer period of time, unplug the adaptor from the wall outlet

and from the unit.

Alarm Backup

In case of a power failure, your set alarms remain stored in the system. Once the power comes

back on, the unit will synchronize its time and date again (provided that DAB+ signal is avail-

able) and the alarm will sound as set.

Basic Functions

Switching the Unit On & Off

1. Power the unit as described above.

2. The unit is now in standby mode. To switch the unit on, press the / Mode button once.

Note: If the unit is switched on for the rst time, it will automatically be in DAB+ mode and

start scanning for available stations (see chapter “DAB+ Mode”).

3. To switch the unit off into standby mode, press the / Mode button once again.

Mode Selection (Switching Between DAB+ and FM)

• With the unit switched on, press and hold for about 2 seconds the / Mode button to

switch between DAB+ and FM modes.

Volume Control

To adjust the volume while in DAB+ or FM mode, rst press the / Select button, followed by

• ▲Up button to increase the volume.

• ▼Down button to decrease the volume.

Display Backlight & Timeout Function

This unit is equipped with a dimmer function (High / Medium / Low) for the display backlight.

To change the backlight level the unit must be in standby mode.

• Press the ▲Up button to increase the dimmer level.

• Press the ▼Down button to decrease the dimmer level.

Note:

• If set to Low or Medium level, the backlight will automatically switch to the High setting

when a button is pressed. To keep the backlight at the same setting when pressing a but-

ton, you need to turn off the “Timeout Function” as desrcibed in the following.

When the radio is switched on you can set a time (Timeout Function) after which the display

backlight should switch back from High setting to the one you set while in standby mode (Low

or Medium):

• While in radio mode (DAB+ or FM) press and hold for 2 seconds the Info / Menu button