Operation Manual

EN - 23

manual adjustments.

Note: Switching the unit off completely or disconnecting it from power supply will

cause the clock to reset. When the unit is turned on again in DAB+ mode, the

clock will automatically reset itself to the correct time (DAB+ signal must be avail-

able).

5.2 FM Mode

In FM mode the time needs to be set manually:

1. Press and hold the Info/Menu key for 2 seconds to enter the menu.

2. Press the Info/Menu key once again to display the menu option “CLOCK”.

3. Press down on the Tune/Select knob to enter the time setting. The hours

are ashing.

4. Turn the Tune/Select knob to select the current hour and press down on this

knob to conrm. Now the minutes are ashing.

5. Turn the Tune/Select knob to select the current minutes and press down on

this knob to conrm.

6. The time is now set and the display will switch back to the frequency.

Note: Switching the unit off completely or disconnecting it from power supply will

cause the clock to reset. If the unit is turned on again in FM mode, the clock does

not reset itself but must be set manually again. For an automatic time setting

switch the unit into DAB+ mode.

DAB+ Mode

1. Storing Stations

You can store up to 8 of your favorite stations to the preset keys, this will enable

you to get access your favorite stations quickly.

1. To store a preset, you must rst be listening to the station that you would like

to save.

2. Then press and hold one of the presets labeled 1-4 for 2 seconds. The LCD

will then show “P# SAVED“.

Note: If you want to save the current station to one of the presets 5 - 8,

press the 4+ key to switch the presets 1-4 to presets 5-8. Then to store

preset 5, for example, press and hold 1 to save preset 5.

“P# SAVED“ will appear in the display.

2. Recalling a Stored Station

Once you have saved a station to one of the presets, you can recall it by pressing

and releasing the corresponding preset key, e.g. if you saved a station to preset 1,

then just press the number 1 preset key.

If you press a preset that hasn’t been allocated a station, then it will display “P#