Operation Manual

EN | 17

3. Switch the mode selector to “AUX”.

4. Adjust the sound with the VOLUME knob or the volume control of the device.

5. When change to another mode, the device will continue to play with no sound until the ON / OFF

switch is adjusted to ‘OFF’ position and switch off the device.

Notes:

• Adjust the ON / OFF switch to the ‘OFF’ position when not in use.

USB / SD CARD READER

1. Set the MODE SELECTOR to “USB/SD”.

2. Insert your USB Flash Drive or SD/MMC Card into the slots. (*If both devices are inserted, it will

only play USB)

3. The unit will search and play all the MP3 formatted les and repeat all tracks automatically.

(*When playing USB Flash Drive, LED indicator will keep ashing in green, when playing SD/

MMC Card, LED indicator will keep ashing in red.

4. Press REPEAT button of the USB-SD control panel while playing to cancel repeat function. Press

again while playing to resume repeat function of all the track.

5. Press ►|| button of the USB-SD control panel to temporarily stop playing. Press again to resume

playing.

6. Press ►►| button of the USB-SD control panel to skip ahead to the next track.(*Press and hold

this button over few seconds to adjust volume up or adjust the main volume control knob)

7. Press |◄◄ button of the USB-SD control panel to skip back to the previous track.(*Press and

hold this button over few seconds to adjust volume down or adjust the main volume control knob)

8. Press EQ button of the USB-SD control panel to change your desired EQ playing mode (*The EQ

mode sequence as Normal>Jazz>Rock>Pop>Classic).

IMPORTANT NOTE:

To avoid malfunction on both your devices, make sure the unit is in off mode before insert the USB

FLASH DRIVE / SD/MMC CARD!

Notes:

• Because of non-standardized format denition/ production of USB Flash Drive or SD Memory

Card, playback quality and performance are not guaranteed.

• Manufacturer is not responsible for the playability of USB Flash Drive or SD Memory Card, due to

recording conditions, such as PC performance, writing software, media ability, etc.

• Manufacturer is not responsible for any loss or damage of data.

• A USB device must always be connected directly to the USB port of this product. The use of a

USB extension cord is not supported by this product. The USB port of this product cannot com-

municate with a computer directly.