Operation Manual
20 | EN
7. On/Standby key
8. Back / Tune Down key
9. Next / Tune Up key
10. Stop / Band / Clock Set key
11. Play / Pause / FM Mode key
12. Function key
13. Volume Down (-) / Folder / Mem - key
14. Volume Up (+) / Folder / Mem + key
15. Remote Control Sensor
16. Speaker (right)
17. FM Antenna
18. Aux In socket
19. Headphone socket
20. Speaker output socket (left & right)
21. AC cord & plug
Remote Control
1. On / Standby key
2. EQ key
3. Function key
4. Back / Tune Down key
5. Play / Pause / FM Mode key
6. Next / Tune Up key
7. ID3 / Sleep key
8. Stop / Band / Clock Set key
9. Volume Up (+) / Folder / Mem + key
10. Snooze / Timer key
11. Mem / Prog. / Play Mode key
12. Volume Down (-) / Folder / Mem - key
13. Battery compartment
First Installation
Connection of Speaker Boxes
• Unwrap the speaker-cords of both speaker-boxes and insert the left/right plugs into sockets in the
rear of main unit.
• Place the speaker boxes as far apart as possible for best sound effect.
Power Supply
• Make sure the set voltage of the unit matches your local voltage.
• Insert the plug of the AC cord into a wall outlet with AC power.
• Press the
On/Standby key to switch “on” the unit.
• This unit is designed to operate without being totally powered “off”. It will either be “on” or in
“standby” mode.
• In standby mode, the blue backlight of the digital display will be dimmed. But the display will show
the current time (clock function).
• Anytime during standby mode, you can switch “on” the unit by pressing the
On/Standby key
(on remote control or front panel of the main unit).
• Save energy by switching the system to “standby” mode when not in use.
Note: How to tell if the power is “ON”?
When the power is “ON” the entire digital display will light up with a blue backlight.