Operation Manual
26 | EN
5. After adjusting “TIMER ON”, “
OFF” appears on the display and the HOUR digit ashes (F2).
6. Repeat the above steps 2 to 3, and then press the TIMER button once more to conrm and order
TIMER OFF time.
7. Now the “TUNER” appears on the display with ashing, and then select the alarm mode of the
“TUNER, CD, USB, CARD or iPod “ by pressing the SKIP/TUNE SEARCH (UP or DOWN) but-
ton.
8. Press the TIMER button again. The timer “VOL” indicator appears on the display and ashes.
Adjust the timer volume high or low by pressing the SKIP/TUNE SEARCH (UP or DOWN) button.
9. Each enable state as shown above will be cleared if the button is not pushed in 10 seconds.
10. After adjusting “TIMER ON” and “TIMER OFF”, press the TIMER button, “ “ appears on the
display.
11. The main unit will be switched on automatically at “TIMER ON” order and start playing, the main
unit will be switched off automatically at “TIMER OFF” order.
Note: If the display shows “ERROR” while you set the “TIMER ON” it means both, “TIMER ON” and
“TIMER OFF”, are the same. In this case, please go to “TIMER OFF” to set the off time rst.
FUNCTION SELECT
When pressing the FUNCTION button the unit switches between its functions in the following order:
RADIO OPERATION
1. Press the FUNCTION button on the main unit (or remote control) to select the TUNER mode and
FM operation.
2. Select the desired frequency with the SKIP/TUNE SEARCH(UP or DOWN) button on the main
unit (or remote control).
MONO/ STEREO SELECT
This unit can receive FM frequency.
1. When you want to select FM stereo station, press the ID3/MONO/ST. button once on the remote
control only. The “ “ indicator will appear on the display that the reception is at its best.
2. When you press the ID3/MONO/ST. button once again, the FM STEREO indicator will turn off &
switch to MONO FM status.
Automatic Tuning
1. Press the SKIP/TUNE SEARCH (UP or DOWN) button for a few seconds, then release the but-
ton. The tuner will automatically search the rst station of sufcient signal strength.
2. Repeat above procedure if you wish to select another station.
Programming preset stations
You can also preset stations of your choice and store up to 30 FM stations in its memory.
1. Tune to the required station.
2. Press the iPod/MEM/CLOCK-ADJ button.
3. Press the PRESET/FOLDER(UP or DOWN) button for your desired station number.
4. Press the iPod/MEM/CLOCK-ADJ again to conrm your selection.
5. To program more stations into the memory, repeat the above steps 2 to 4.
6. To change the stored preset stations, repeat the above steps 2 to 4.
Notes:
• Storing a new station into a preset location will erase the previously stored station in that location.
• To erase all preset memory press and hold the PLAY/PAUSE button while the unit is in STANDBY
mode.