Operation Manual

EN | 21
EN
exces over 1-3/4” if a shim is necessary, longer screws are required. Longer screws (Type#10-
32) are available at most local hardware stores Cut out the template on the line indicated. The
template size and the screw hold positions are identical to the top of the clock radio.
Step 1
If your cabinet does not have a overhang :
a) Position template in desired location on underside of cabinet, ush with front edge.
b) Then tape template in pace and go to step 2.
Front edge of
cabinet
Template
If your cabinet has overhang:
a) Measure the thickness of the overhang.
b) Fold front of the template downward along the printed guideline that is closet to the thickness of
your cabinet.
c) Tape fold-down portion to backside of overhand, tape template to cabinet underside.
Note: If your cabinet has glue blocks or other obstructions, cut out corresponding areas on the tem-
plate to clear them. Do not cut or cut through the screw holes indicated on the template.
CAUTION: It is recommended that safety glasses be worn while drilling screw holes to prevent the
possibility of eye injury.
Fold template on dot-
ted line
Measure thickness of
cabinet overhang
Step 2
Drill 1/4” inches diameter holes through the underside of the cabinet bottom shelf using the three
points marked on the template.
Step 3
Remove template and clean drill shavings from inside and underside of cabinet.
Step 4
If your cabinet does not have an overhang. Go to Step 5.
If your cabinet has an overhang. Select the spacer or combination of spacers that is equal to or longer
than the cabinet overhang.