Operating instructions

Maintenance

Brush Removal & Bearing Cleaning

NOTE: The brushes should wear evenly side to side.

Brushes should be replaced as a set when bristle

length wears to height of yellow PerformAlert™

bristles.

The brushes are removed from the right side of the

machine.

1. Release door spring clips and rotate the brush door

up.

2. Slide the brushes out the side opening.

3. Remove bearing cap from end of brush.

4. Clean bearings and cap.

Brush Installation

1. Slide brush through door opening and onto drive

shaft. Make sure it is fully seated and is driven by

the deck system.

2. Rotate the brush caps until the indicator lines on

the ends are vertical.

3. Lower the brush door and ensure both spring clips

engage.

Side Broom Removal

1. Remove cotter and clevis pins from side broom

assembly.

2. Slide side broom from assembly.

3. Reverse process to assemble.

Belt Replacement

1. Remove three (3) cover screws and cover.

2. Push belt tensioner to the left as shown to release

belt tension. Remove belt and discard.

3. Thread new belt through pulley’s and tensioner.

4. Re-install cover.

NOTE: Belt must be installed with lettering facing out.

If installed incorrectly this may cause excessive noise

SPRING CLIP

VERTICAL INDICATOR LINE

SPRING CLIP

CLEVIS PIN

COTTER PIN

COVER

BELT TENSIONER

BELT

8.644-672.0 Operator Manual - Chariot 3 - CV86/1 RS Bp