Operating instructions

Maintenance

Transporting

Pushing Machine

The machine may be pushed for short distances at

speeds not to exceed 5 mph. Be careful to avoid

damaging machine. The machine may be pushed by

hand from the rear.

NOTE: To avoid damage caused by regenerative

voltage, disconnect traction motor before towing or

pushing machine.

Machine Tie-Downs

There are four tie down points, two on the front wheel

guards, and two on the rear axle located on either side

of the foot box.

Trailer Loading/Unloading

Brush deck must be in the up position before loading.

Once loaded, lower brush deck, turn off machine, and

ensure brake is engaged. Block the tires to prevent the

machine from rolling and tie down machine using

indicated anchor points.

Reverse process to unload.

8.644-672.0 Operator Manual - Chariot 3 - CV86/1 RS Bp

Tie down point

Wheel Guards

Rear Axle

(Both sides)