Full Product Manual
Table Of Contents
- FLOOR CLEANER OPERATOR MANUAL
- Contents
- IMPORTANT SAFETY INSTRUCTIONS
- Customer Service
- Technical data
- Description of the unit
- Installation
- Initial startup
- Operation
- Care and service
- Troubleshooting guide
- Disposal
- MANUEL OPERATEUR NETTOYEUR DE SOL
- Contenu
- CONSIGNES DE SECURITE IMPORTANTES
- Service à la clientèle
- Caractéristiques techniques
- Description de l'appareil
- Montage
- Mise en service
- Utilisation
- Entretien et maintenance
- Dépannage en cas de défaut
- Élimination
- MANUAL DEL OPERADOR DEL LIMPIADOR DE PISO
- Índice de contenidos
- INTRUCCIONES DE SEGURIDAD IMPORTANTES
- Servicio al cliente
- Datos técnicos
- Descripción del equipo
- Montaje
- Puesta en funcionamiento
- Servicio
- Cuidado y mantenimiento
- Ayuda en caso de fallos
- Eliminación de residuos
English 17
6. The display indicators light up re-
peatedly from top to bottom.
The rinsing process begins and
takes about 2 minutes.
Note
At the beginning of the rinsing process,
the water runs from the fresh water
tank onto the rollers for about 80 sec-
onds. During this time, the device is
noiseless. Only at the end of the rins-
ing process do the rollers begin to turn
for approx. 30 seconds.
7. When the rinsing process is com-
plete, a signal tone sounds and the
display "MAX" (red) lights up.
8. Press the unlocking button for th
e
waste water tank and place the de-
vice on the parking station. The
waste water
tank remains
in the
cleaning station.
Note
If you try to switch the device on again
when the waste water tank is full, the dis-
play "MAX" (red) flashes for 10 seconds.
It is not possible to continue to clean.
9. Push the unlocking button for th
e
hair filters inwards.
The hair filters come off.
10.Place the hair filters in the cleaning
station.
11.Remove the rollers and place them
in the cleaning station.
3
sec
ca. 2 min
a
c
b