Operating instructions
6
Tips for working with the cleaner
Carpeting, carpets and above all genuine
Oriental carpets should be tested in an
inconspicuous place to make sure they
are colourfast and water resistant
– The more sensitive the covering (Oriental
rugs, Berber carpets, upholstery material),
the less detergent should be used.
– Hemp-backed carpeting can shrink if it is
worked too wet and the colour will run.
– Brush deep pile carpets when they are wet
in the direction of the pile (e.g. with a pile
brush or scrubber).
– You will achieve better cleaning results if
you use warm water (up to a max. 50 °C).
– Spray badly stained areas separately and
leave the detergent for 5–10 mins to take
effect.
– Always work from light to dark, that means
from windows to doors.
– Always work from the cleaned area to the
non-cleaned area.
– After a textile covering has been cleaned
wet, it should be treated to prevent it from
becoming dirty again too quickly.
– Do not walk on cleaned areas or place
furniture on them until they have dried (risk
of rust stains or pressure marks).
– For carpets which have been shampooed,
the foam in the dirty-water reservoir has to
be neutralised.
Detergents
Environmental note: We recommend you use
detergents sparingly out of consideration for
the environment. Please follow precisely the
instructions about how much to use.
Caution: To prevent injury to health or damage
to property, please observe all instructions
which are included with the detergents used.
Closing down
Empty fresh-water tank
Note: The fresh-water tank can be emptied
simply by suction.
n Take floor nozzle off spray-suction hose.
n Hold suction hose in the unused cleaning
solution in the fresh-water tank and switch
on the unit with the “suction” button (Fig. 9).
n The cleaning solution which has been
suctioned off collects in the dirty-water
reservoir.
n Take out dirty-water reservoir and empty it.
Clean unit and accessories
n Put floor nozzle on spray-suction hose.
n Fill fresh-water tank with approx. 2 litres of
tap water (use no detergent) and place floor
nozzle in fresh-water tank.
n Switch on “spray” button and let the unit and
accessories rinse thoroughly for approx.
1–2 mins. (Fig. 10).
n Switch unit off and pull the power plug out of
the socket.
n Operate valve handle in the floor nozzle, in
this way pressure in the system is removed.
n Pull out spray-suction hose on the unit and
the suction tube.
n Empty dirty-water reservoir and fresh-water
tank.
n Clean unit.
n The floor nozzle can be locked in the
carrying handle for storage purposes or for
transporting the unit (Fig. 12).
English