Operating instructions

– 5
This battery powered pressure cleaner should be used
for private households only:
– for cleaning machines, vehicles, buildings, tools,
façades, terraces, garden machines etc. by means
of a water stream.
– with accessory parts and spare parts approved by
KÄRCHER.
Only use original accessories and spare parts, they en-
sure the safe and trouble-free operation of the device.
For information about accessories and spare parts,
please visit www.kaercher.com.
Only special accessories with the note "Handheld" (with
blue plug) can be used.
Note: Spray lances from high-pressure cleaners are not
compatible.
– Batteries / chargers that are not supplied in the
scope of delivery or are additionally required are
available as special accessories or can be pur-
chased later.
– Fast charger and battery pack with a larger capac-
ity are available as special accessories.
The scope of delivery of your appliance is illustrated on
the packaging. Check the contents of the appliance for
completeness when unpacking.
In the event of missing accessories or any transport
damage, please contact your dealer.
These operating instructions describe the maximum
equipment. Depending on the model, there are differ-
ences in the scopes of delivery (see packaging).
Illustrations on Page 2
Illustration
1 Dirt blaster
For strong contaminations.
2 Nozzle release
3 Flat jet nozzle
For normal cleaning tasks.
4 Spray lance
5 Pressure cleaner (battery powered)
6 Water connection with fine filter
7 Power switch
8Lock
9 Battery pack release
10 Coupling element for water connection
Note:The device can only be operated with 18 V battery
packs and is not compatible with 36 V battery packs.
Illustration
 See operating instructions for the battery pack and
charger used.
몇 CAUTION
Risk of personal injury or damage! Ensure that the bat-
tery pack properly snaps into place.
Illustration
 Insert the battery pack into the intake of the device.
Illustration
 Insert the spray lance and lock it by turning it 90°.
 Press the desired nozzle onto the spray lance until
it audibly clicks into place.
Note: To disconnect the nozzle, press the nozzle
release down and pull the nozzle off.
For connection values, see type plate/technical data.
Observe regulations of water supplier.
Illustration
 Screw the coupling element to the water connec-
tion on the appliance.
 Use a 1/2 inch water hose (not included in the
scope of delivery) with a commercially available
coupling.
 Attach the water supply hose to the coupling on the
water connection.
 Connect the water supply hose to the water supply.
 Completely open the water tap.
This pressure cleaner can be used with KÄRCHER suc-
tion hose SH 5 Handheld (special accessory, order no.
2.644-124.0) for suctioning surface water (e.g. from wa-
ter butts or ponds).
Note: The max. suction height is 0.5 m.
 Screw the suction hose into the water connection of
the appliance and insert it into the water source
(e.g. rainwater drum).
Proper use
Accessories and Spare Parts
Special accessories
Information on battery pack and charger
Scope of delivery
Description of the Appliance
* Optional
11* Battery pack Battery Power 18/25
12* Standard charger Battery Power 18 V
Additionally required
– Fabric-reinforced water hose with commercially
available coupling.
Minimum diameter, 1/2 inches (13 mm).
– KÄRCHER suction hose SH 5 Handheld
(order no. 2.644-124.0)
Start up
Charging the battery pack
Inserting the battery pack
Attaching the spray lance
Water supply
Water supply from mains
Drawing in water from open reservoirs
10 EN