SC 5 EasyFix Premium Iron Plug Operating Instructions Please read the operating instructions carefully before using the unit.
A 10 9 14 11 8 15 16 17 18 16 19 13 7 6 4 5 12 5 4 20 3 21 2 1 22 26 25 23 24 35 33 27 34 36 29 37 31 30 38 32 39 44 47 46 40 41 2 49 45 42 48 43 28
B C D E F G H I J 1. 2.
N O P 1. 2.
Safety instructions Steam cleaner Please read and comply with these original instructions prior to the initial operation of your appliance and store them for later use or subsequent owners. You also need to take into consideration the general safety regulations and accident prevention guidelines of the legislator in addition to the notes in the operating instructions. Warnings and information notices attached to the device provide important information for hazard-free operation.
tection. Never modify or bypass safety devices. Risk of electric shock DANGER Never touch the mains plug and socket with wet hands. Only connect the device to alternating current. The voltage indicated on the type plate must match the voltage of the power source. Do not direct the steam jet directly onto equipment containing electrical components, e.g. the interior space of ovens.
Risk of scalding from high water output if you tilt the due to more than 30° to the side when using it. Applies to SC 1 devices only Risk of scalding on the hot steam boiler. Allow the steam boiler to cool down before filling it with water. Does not apply to SC 3 devices lNever disconnect accessories from the device while steam is being expelled. Hot water may drip out when disconnecting accessory parts. Allow the device to cool down first. Never open the maintenance / safety lock during operation.
Care and service 몇 WARNING Only carry out servicing work when the mains plug is pulled and the steam cleaner has cooled down. 몇 CAUTION Have repair work carried out by the authorised customer service only. Descaling the steam boiler Does not apply to SC 3 devices 몇 CAUTION Never screw the safety lock onto the device while descaling. Do not use the steam cleaner while there is descaler in the boiler. ATTENTION The descaler may corrode sensitive surfaces.
Contents General notes. . . . . . . . . . . . . . . . . . . . . . . . . . . . Intended use. . . . . . . . . . . . . . . . . . . . . . . . . . . . . Environmental protection . . . . . . . . . . . . . . . . . . . Accessories and spare parts . . . . . . . . . . . . . . . . Scope of delivery . . . . . . . . . . . . . . . . . . . . . . . . . Warranty . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Safety devices . . . . . . . . . . . . . . . . . . . . . . . . . . . Device description . . . . . .
Device description 40 **Microfibre floor cloth (2 x) The maximum amount of equipment is described in these operating instructions. Depending on the model used, there are differences in the scope of delivery (see packaging). For the figures, refer to the graphics page.
Operation Refilling water Filling water The water reservoir can be removed at any time for filling or be filled directly at the device. ATTENTION Damage to the device Unsuitable water can block the nozzles or damage the water level indicator. Do not fill in pure distilled water. Use a maximum of 50% distilled water mixed with tap water. Do not use condensation from the clothes dryer for filling. Do not use collected rain water for filling. Do not use cleaning agents or other additives (e.g.
Storing the device Spotlight nozzle 1. Store the round brush in the accessory compartment. 2. Connect a manual nozzle to one extension tube. 3. Connect the extension tubes to the accessory holders. 4. Insert the spotlight nozzle in the storage for accessories. 5. Hang the floor nozzle in the park bracket. Illustration Q 6. Wind the steam hose around the extension tube and connect the steam gun to the floor nozzle. Illustration R 7. Store the mains cable in the storage for the mains cable. 8.
2. Push the floor nozzle onto the extension tube. Illustration K 3. Fasten the floor cleaning cloth to the floor nozzle. a Place the floor cleaning cloth with the hook and loop strips pointing upwards on the floor. b Place the floor nozzle onto the floor cleaning cloth, applying slight pressure. Illustration L The floor cleaning cloth will stick to the floor nozzle of its own accord due to the hook and loop fastening. Removing the floor cleaning cloth 1.
Continuous steaming: Pull the lock for the “steam” switch backwards until it engages. Steam flows out continuously. To release, push the lock forward. 3. Before ironing and after pauses in the ironing process, direct the blast of steam onto a cloth until the steam flows evenly. Dry ironing ATTENTION Damage to the device Water shortage in the steam boiler leads to damage to the device Make sure that there is water in the steam boiler.
Long heating-up time The steam boiler is scaled. Descale the steam boiler. High water output The steam boiler is scaled. Descale the steam boiler. VapoHydro steam stage set. Turn the selector switch to the steam setting selection range. The steam pressure iron “spits” water Set the temperature controller to stage . Rinse or descale the steam boiler of the steam cleaner; see Chapter Descaling the steam boiler.
www.kaercher.com/dealersearch Alfred Kärcher SE & Co. KG Alfred-Kärcher-Str. 28-40 71364 Winnenden (Germany) Tel.
