Operating instructions

English 15
Device description
Overview of the unit
See graphics page
1 Hubcap
2 Nozzle holder
3 Skid
4 Type plate
5 Nozzle storage for triple nozzle
6 Transport retainer for surface cleaner
7 Push handle lock
8 Push handle, bottom (pushed in)
9 Push handle, top (pulled out)
10 High-pressure nozzle
11 High-pressure nozzle marking
12 EASY!Lock spray lance
13 EASY!Force high-pressure gun
14 Safety latch
15 Trigger
16 Safety lever
17 EASY!Lock high-pressure hose
18 Hose storage compartment
19 Cable clips
20 Spray lance holder without a clamp
21 Rubber band (not in devices with a hose reel)
22 Nozzle storage compartment for rotary nozzle (rota-
ry nozzle only included in the scope of delivery of
the "Plus" variant)
23 Spray lance holder with a clamp for transport
24 Power switch
25 Handle
26 EASY!Lock high-pressure connection
27 Handle
28 Water connection
29 Detergent suction hose with filter and detergent
dosing unit
30 sieve
31 Hose spout
32 Union nut
33 Crank
34 Hose reel
Colour coding
 Control elements for the cleaning process are yel-
low.
 Control elements for maintenance and servicing are
light grey.
Installation
Fastening the hubcaps
 Fasten the hubcaps.
Installing accessories
Note
The EASY!Lock system connects components quickly
and safely via a single turn of the quick-release thread.
1. Fit the high-pressure nozzle onto the spray lance
with the marking facing upwards.
2. Tighten the high-pressure nozzle hand-tight
(EASY!Lock).
3. Connect the spray lance to the high-pressure gun
and hand-tighten (EASY!Lock).
4. Release the push handle lock.
5. Pull the push handle out to the end position.
For devices without a hose reel:
6. Connect the high-pressure hose to the high-pres-
sure gun and high-pressure connection of the de-
vice and tighten hand-tight (EASY!Lock).
For devices with a hose reel:
7. Lay the high-pressure hose on the ground in a
straight line.
8. Insert the crank into the hose reel shaft and latch in-
to position.
9. Turn the crank clockwise and wind the high-pres-
sure hose onto the hose reel in evenly distributed
layers.
10. Connect the high-pressure hose to the high-pres-
sure gun and hand-tighten (EASY!Lock).
Electrical connection
 DANGER
Failure to disconnect the mains
Risk of injury from electric shock
Use a plug to connect the device to the mains grid. Per-
manent connection to the mains grid is prohibited. The
plug is used for disconnection from the mains.
1. Unwind the mains cable and place on the ground.
2. Plug the mains plug into the socket.
Water connection
Connection to a water line
몇 WARNING
Return flow of dirty water into the drinking water
network
Health risk
Observe the regulations of your water supply company.
According to applicable regulations, the device must
never be used with the drinking water network without a
system separator. Use a system separator from
KÄRCHER or a system separator as per EN 12729
2.
1.