Operating instructions

- 10
 Push the appliance forward about 2 m
so that the steering rollers point toward
the rear.
 Lower the cleaning head.
 Empty the solution and recovery tank .
 Loosen the tank lock and tilt the tank
upwards.
 Place the batteries in the tray close to
each other towards the cleaning head
and fasten them to the floor using the
included holding blocks.
CAUTION
When the batteries are installed and re-
moved, the stability of the appliance can be
compromised; ensure a safe stance.
 Connect the connection cable to the
free battery poles (+) and (-).
 Connect pole using the enclosed con-
necting cable.
몇 Warning
Pay attention to correct poles.
Installation sketch for 2 batteries
 Swivel the water reservoir all the way
down, check the lock.
Note
Charge the batteries before commissioning
the appliance.
See also "Charging the batteries".
CAUTION
Risk of damage due to tipping appliance;
remove batteries only if the appliance is
equipped with a cleaning head.
 Remove the Intelligent Key.
 Push the appliance forward about 2 m
so that the steering rollers point toward
the rear.
 Lower the cleaning head.
 Loosen the tank lock and tilt the tank
upwards.
 Remove the connection for the minus
pole of the battery.
 Remove the remaining connector from
the battery
 Remove the support blocks or the foam
pieces.
 Remove the batteries.
CAUTION
When the batteries are installed and re-
moved, the stability of the appliance can be
compromised; ensure a safe stance.
 Dispose of the used batteries according
to the local provisions.
To ensure a reliable operation of the appli-
ance maintenance contracts can be con-
cluded with the competent Kärcher sales
office.
In case of danger of frost:
 Empty the solution and recovery tank .
 Store the appliance in a frost-protected
room.
Insert batteries and connect
Removing the batteries
Maintenance contract
Frost protection
12 US