Operating instructions

– 6
 Switch off the appliance using the On/
Off switch.
 If necessary, dismantle the accessory
and rinse it with water and let dry.
 Empty the vacuuming material contain-
er (refer chapter "Emptying vacuuming
material container").
 Vacuum and wipe the appliance inside
and outside with a damp cloth.
Note
The vacuum material container must be
emptied when it is has filled up to approx. 3
cm below the upper edge.
Regularly check the filling level in the dirt
receptacle, since the device does not
switch off automatically.
 Switch off the appliance and secure it
using the parking brakes at the guide
rollers.
 Open the vacuum material container
upwards at the unlocking mechanism.
 Pull out the vacuuming material con-
tainer from the appliance using the han-
dle that has been provided for the pur-
pose.
 Empty the vacuuming material contain-
er and insert it back into the appliance
using the reverse sequence.
Note
The vacuum material container can be lift-
ed by cranes at the handle. Maximum load
for crane transport: 50 kg.
몇 CAUTION
Risk of injury and damage! Note the total
weight of the vacuum material container
when transporting with a crane. Do not
overload the container. Observe instruc-
tions on lifting with a crane.
You can insert a dust collector in the vacu-
uming material container to empty the ap-
pliance without causing dust.
Do not use the dust collection bag for wet
vacuum cleaning!
 Insert the dust collection bag into the
container and attach it carefully to the
container wall.
 Put over the edge of the bag over the rim
of the vacuuming material container.
 Insert the vacuuming material container
back into the appliance.
 After finishing use, close the dust col-
lection bag and remove it from the vac-
uuming material container.
 Dispose off the dust collection bag with
its contents according to the applicable
regulations.
 Lock parking brakes.
 Remove the tin tub.
 Pull the locks of the placement mechan-
ics up.
 Pull the push handle upward. The dis-
posal system is unlocked and lowered.
 Pull the disposal system out by the handle.
 Reinsert the disposal system and lock it
with the push handle.
몇 WARNING
Risk of crushing! Under no circumstances
should you hold your hands between the
disposal system and spacer or allow them
to come close to the lifting mechanism
while locking it. Hold the disposal system
by the handle with one hand and lock it with
the other by actuating the push handle.
 Insert the tin tub.
Shutting down
Emptying the vacuuming material
container
Dust collection bag
LP appliances
Remove the disposal system
Insert the disposal system
18 EN