Operating instructions

13
STEP 9: Turn the burner switch
“ON”. Turn thermostat dial to the
210° mark.
STEP 10: (Pump Steam Option)
A. Operate machine as instructed.
B. Open steam valve counterclock-
wise, which will lower
pressure.
C. Turn thermostat knob to 250°F.
D. When steam is no longer
desired, Turn steam valve
clockwise and thermostat knob to
200°F.
WARNING! Never replace
nozzle without engaging the
safety latch on the spray gun
trigger.
AVERTISSEMENT: Ne jamais
remplacer les buses sans
d'abord mettre le dispositif de
sécurité sur la détente du
pistolet pulvérisateur.
Karcher HDS 600-612 Operator’s Manual 9.800-080.0 - BH
AVERTISSEMENT: Le retour du cordon de lancement
(rétraction rapide) peut causer des lésions corporelles.
La rétraction rapide de la corde du démarreur (recul)
attire la main et le bras vers le moteur plus vite qu'il
n'est possible de lâcher la corde. Toujours réduire la
pression du pistolet pulvérisateur avant de tirer sur le
cordon de lancement. Tirer lentement sur le cordon de
lancement jusqu'à ce qu'une résistance soit sentie,
puis tirer rapidement.
On-Off
Switch
STEP 7: (Electric Start Models) Turn the engine
switch to "Start" position.
ON
OFF
START
Engine
Switch
STEP 8: (Electric Start Models) Turn the key to the
START position, and hold it there until the engine
starts. If the engine fails to start within 5 seconds,
release the key, and wait at least 10 seconds before
operating the starter again.
Using the electric starter for more than 5
seconds at a time will overheat the starter motor
and can damage it.
When the engine starts, release the key, allowing it
to return to the ON position. If the choke knob has
been pulled to the CLOSED position to start the
engine, gradually push it to the OPEN position as
the engine warms up.
Thermostat
Burner
Switch
Steam
Valve
Safety
Latch