Use and Care Manual

8 English
 STEP 7:
Slide the retention clip on the reel (as
indicated by “1” below) then com-
pletely push the high- pressure hose
in (as indicated by “2” below) until
you hear a click.
Tug on the hose before proceeding
to make sure it is securely installed.
It should not come loose when you
tug on it.
 STEP 8:
Push the high-pressure hose into the
trigger gun until it locks audibly.
Note: Make sure the connection nip-
ple is aligned correctly.
Check the secure connection by pull-
ing on the high-pressure hose.
Disconnect:
 Press the disconnect key on the trig-
ger gun and remove the high-pres-
sure hose from the trigger gun.
This pressure washer has been tested
by Kärcher's quality assurance team. A
small amount of water may be present in
the water inlet or outlet. This is normal
and will not affect the performance of the
pressure washer.
 STEP 1:
Insert the spray wand of your choice
into the trigger gun. Press in against
the spring tension and twist into
locked position.
 STEP 2:
Install the water inlet connector to the
unit’s water inlet.
Note: Never attach the garden hose
connector to the unit’s water inlet!
Install high- pressure hose to hose
drum
Connect the high-pressure hose to
the trigger gun
OPERATING
INSTRUCTIONS