Quick Start Manual

ManualsBrandsKarcher ManualsPower EquipmentKarcher 40 RS BP (1.006-132.0)

QUICKSTART

5.964-039.0 02/11

Warning

These are only brief instructions! Please read and comply with these instructions prior to using or servicing your

appliance.

The non-compliance of the operating and safety instructions may lead to damages of the appliance and to dangers

for the operator and other persons.

Start up

A B A Unplug the charger from the mains.

B Place the mains cable into the storage

compartment.

A Open the cover of the fresh water reservoir.

Fill in fresh water (maximum 60 °C). Leave

sufficient space for the detergent.

Close the cover of the fresh water reservoir.

B Connect the hose to the automatic filling

system and open the water supply (max.

60°C).

Monitor the appliance - the automatic filling

system will interrupt the water supply when

the tank is full.

Shut off the water supply and disconnect the

hose from the appliance.

A B A Pour in detergent.

B Open fresh water valve.

BR/BD 55/40 RS

Summary of content (7 pages)

PAGE 1
QUICKSTART BR/BD 55/40 RS Warning These are only brief instructions! Please read and comply with these instructions prior to using or servicing your appliance. The non-compliance of the operating and safety instructions may lead to damages of the appliance and to dangers for the operator and other persons. Start up 1 A 2 A B A Open the cover of the fresh water reservoir. Fill in fresh water (maximum 60 °C). Leave sufficient space for the detergent. Close the cover of the fresh water reservoir.
PAGE 2
QUICKSTART Operation 1 A B Starting the machine A Step on the standing platform. Do not press the accelerator pedal. B Release emergency-stop button by turning. C Set main switch to “1”. C 2 A B Drive forward A Set the forward drive direction using the drive direction button at the operator console. B Set the speed range on the programme selection switch. C Press accelerator pedal down slowly. Release the accelerator pedal, the machine brakes automatically and stops.
PAGE 3
QUICKSTART Operation 5 A 6 A 7 A Scrubbing suction A High cleaning intensity Wet clean the floor and vacuum up dirt water. Vacuuming A Suck in the dirt fleet. Apply detergent solution A Apply detergent solution to the severelyk contaminated surface and let it soak in. Finish operation 1 A 2 A 3 A B C Turn off the appliance A Set programme switch to step 1 (driving). B Turn key to "0" and remove it. C Press emergency-stop button. Turn off the water supply A Close the fresh water valve.
PAGE 4
1 A 몇 weekly daily Maintenance and care Kärcher Customer Service QUICKSTART Warning Please observe the local provisions regarding the wastewater treatment. A Take the water discharge hose from the support and lower above a suited collection device. B Then rinse the dirt water tank with clear water. B 2 A A Open the lock. Swivel the top of the appliance forward. Check and ensure that the top of the appliance is seated properly on the wastewater reservoir.
PAGE 5
A A weekly daily Maintenance and care Kärcher Customer Service QUICKSTART BD model A Check brush for wear and tear and clean it. If the bristles are as long as the indicator bristles, they must be replaced. BR model A Check the brushes for wear (bristle length at least 10 mm), replace if required. Check brushes for wear and tear, clean. 6 A 7 A A Clean the outside of the appliance with a damp cloth which has been soaked in mild detergent. 8 A A Charge battery.
PAGE 6
QUICKSTART Troubleshooting 1 2 3 A B C D E F A Appliance cannot be started A Step on the standing platform. Do not press the accelerator pedal. B Release emergency-stop button by turning. C Set main switch to “1”. D Unplug the charger from the mains. E Battery depleted. Charge battery. F Close the solenoid brake. To do this, press the lever of the solenoid brake all the way up to the stop.
PAGE 7
QUICKSTART Troubleshooting 4 A 5 A The battery indicator blinks A Charge battery. A B Insufficient cleaning result BD model A Check brush for wear and tear and clean it. If the bristles are as long as the indicator bristles, they must be replaced. BR model A Check the brushes for wear (bristle length at least 10 mm), replace if required. Check brushes for wear and tear, clean. B Charge battery. 6 A B Brushes do not turn A Reset fuse of brush drive. B Charge battery.