Safety data sheet

Page 5/11
Safety data sheet
according to 1907/2006/EC, Article 31
Printing date 03.12.2021 Revision: 21.06.2021Version number 7 (replaces version 6)
Trade name:
PressurePro Intensive Deep Cleaner RM 750
(Contd. of page 4)
53.2.5
SECTION 8: Exposure controls/personal protection
·
8.1 Control parameters
·
Ingredients with limit values that require monitoring at the workplace:
1310-58-3 potassium hydroxide
WEL Short-term value: 2 mg/m³
·
8.2 Exposure controls
·
Appropriate engineering controls
No further data; see item 7.
·
Individual protection measures, such as personal protective equipment
·
General protective and hygienic measures
Keep away from foodstuffs, beverages and feed.
Immediately remove all soiled and contaminated clothing
Wash hands before breaks and at the end of work.
Do not inhale gases / fumes / aerosols.
Avoid contact with the eyes and skin.
·
Respiratory protection:
Filter A/P2.
In case of brief exposure or low pollution use respiratory filter device. In case of intensive or longer exposure
use self-contained respiratory protective device.
Not necessary if room is well-ventilated.
·
Hand protection
Protective gloves.
·
Material of gloves
Butyl rubber, BR
·
Penetration time of glove material
The exact break trough time has to be found out by the manufacturer of the protective gloves and has to be
observed.
·
For the permanent contact gloves made of the following materials are suitable:
* butyl rubber 0,7 mm, 480 min (EN 374)
·
For the permanent contact of a maximum of 15 minutes gloves made of the following materials are
suitable:
Nitrile rubber, NBR
·
Eye/face protection
Tightly sealed goggles (EN 166)
·
Body protection:
Boots
Apron
GB
(Contd. on page 6)