Safety data sheet

Page 5/11
Safety Data Sheet
according to WHS Regulations
Printing date 15.10.2021 Revision: 06.10.2021Version number 6
Trade name:
PressurePro Oil and Grease Cleaner Extra RM 31
(Contd. of page 4)
53.1.25
·
Control parameters
·
Ingredients with limit values that require monitoring at the workplace:
1310-73-2 sodium hydroxide
WES Peak limitation: 2 mg/m³
·
DNELs
1310-73-2 sodium hydroxide
Inhalative DNEL 1 mg/m3 (employee)
1 mg/m3 (consumer)
·
Exposure controls
·
Personal protective equipment
·
General protective and hygienic measures
Keep away from foodstuffs, beverages and feed.
Immediately remove all soiled and contaminated clothing
Wash hands before breaks and at the end of work.
Do not inhale gases / fumes / aerosols.
Avoid contact with the eyes and skin.
·
Respiratory protection:
Use suitable respiratory protective device only when aerosol or mist is formed.
Short term filter device:
Filter A/P2.
In case of brief exposure or low pollution use respiratory filter device. In case of intensive or longer exposure
use self-contained respiratory protective device.
Not necessary if room is well-ventilated.
·
Protection of hands:
The glove material has to be impermeable and resistant to the product/ the substance/ the preparation.
Selection of the glove material on consideration of the penetration times, rates of diffusion and the degradation
Protective gloves.
·
Material of gloves
Butyl rubber, BR
·
Penetration time of glove material
The exact break trough time has to be found out by the manufacturer of the protective gloves and has to be
observed.
·
For the permanent contact gloves made of the following materials are suitable:
* butyl rubber 0,7 mm, 480 min (EN 374)
·
As protection from splashes gloves made of the following materials are suitable:
* nitril rubber 0,4 mm, 30 min (EN 374)
·
Eye protection:
Tightly sealed goggles (EN 166)
·
Body protection:
Alkaline resistant protective clothing
(Contd. on page 6)
AU