Instructions

EN | 13
EN
9. Pick-up holder
10. Line Out socket
11. Auto stop switch
12. AC cord
Connection
1. Connect the mains plug of the unit to a suitable power outlet. Make sure that the output power of
the outlet matches the power supply as indicated on the unit‘s rating label on the back.
2. Turn the On/Off/Volume knob clockwise to turn the unit on. The power indicator LED will light up
red. The unit is turned on and records can be played.
Turntable
Noets:
• Remove the stylus protector.
• Be sure that the tone arm is being detached from the tone arm rest
before operating and re-secured again afterwards.
1. Turn on the system until the power LED light up.
2. Set the speed selector to the proper position depending on the record to
be played.
3. Place the record on the platter (use the spindle adaptor if required).
4. Lift the tone arm from the rest and slowly move it to the record side. The plat-
ter will start to rotate.
5. Place the tone arm to the desired position of the record.
6. Adjust the volume to the desired level.
7. At the end of record, the platter will automatically stop rotating. Lift the tone
arm from the record and return it to the rest.
8. To stop manually, lift the tone arm from the record and return it to the rest.
Note:
For some records the auto-stop area may be out of the unit setting, i. e. it will stop before the last
track is nished. In this case set the auto-stop switch to “Off“ position. It will now play to the end of the
record but will not stop automatically (turn off the unit by power button or switch back the auto-stop
switch to “On“ position to stop the platter rotate). Then put back the tone arm to the rest position.
Headphone Connector
Connect one pair of headphones (not included) to the 3,5 mm headphone connector located at the
unit front. Once headphones are connected the speakers are deactivated. To reactivate the speakers,
disconnect the headphones.
Cartridge
Stylus
assembly
7
8
9
11