Operating instructions

– 10
Illustration
 For appliances with built-in socket:
Connect the mains plug of the electric
power tool to the vacuum cleaner.
Illustration
-Switch the appliance on (move the rotary
switch to the left to position MAX)
and start working.
Note: As soon as the electric tool is
switched on, the suction turbine starts with
a 0.5 second delay. If the electric tool is
switched off, the suction turbine continues
to run for approx. 5 seconds in order to vac-
uum up the remaining dirt in the suction
hose.
The filter cleaning system is intended for
vacuuming up large volumes of fine dust
without an inserted filter bag.
Note: Thanks to the filter cleaning system
the soiled flat pleated filter can be cleaned
at the push of the button and the suction
performance can be increased again.
Illustration
 Place the handle of the suction hose in
the accessory compartment on the ap-
pliance head. Push the filter cleaning
button 3 x while the appliance is
switched on, wait 4 seconds between
the individual operations.
Note: After operating the filter cleaning but-
ton several times, check the container for
its filling volume. Otherwise, the dirt might
escape when the container is opened.
Cleaning hard to reach locations or, where
vacuuming is not possible, like leaves from
a gravel bed.
Illustration
 Connect the suction hose to the blower
connection, this will activate the blower
function.
Illustration
 Turn off the appliance.
Illustration
 Hook the floor nozzle into the parking
position.
 Turn off the appliance and disconnect
the mains plug.
Illustration
 Remove the appliance head and empty
the reservoir filled with wet or dry dirt.
For appliances with drain screw:
Empty the dry dirt over the container.
Use the drain screw to empty liquids.
Illustration
 Stow away the mains cable and acces-
sory at the machine. Store the appli-
ance in a dry room.
Integrated filter cleaning system
Blowing function
Interrupting operation
Finish operation
Empty the container
Storing the appliance
10 EN