Owner manual

ManualsBrandsKarcher ManualsSpecial machineryB 60 W roller

QUICKSTART

5.964-272.0 10/12

Warning

These are only brief instructions! Please read and comply with these instructions prior to using or servicing your

appliance.

The non-compliance of the operating and safety instructions may lead to damages of the appliance and to dangers

for the operator and other persons.

Start up

A B A Unplug the charger from the mains.

B Wind the mains cable around the cable hold-

ers.

A B A Open the lock of the fresh water reservoir.

Fill fresh water (maximum 60 °C) until the

lower edge of the filling nozzle.

Close the lock of the fresh water reservoir.

B Connect the hose to the automatic filling

system and open the water supply

(max. 60 °C, max. 5 bars).

A B Model with dosing equipment "Dose"

A Place the detergent bottle into the holder.

Close the bottle lid.

Insert the suction hose of the dosaging

equipment into the bottle.

Model without dosing equipment "Dose"

B Add the detergent to the fresh water

reservoir.

Operation

A B Starting the machine

A Turn the program selection switch to "OFF".

B Plug in the Intelligent Key.

B 60

Summary of content (6 pages)

PAGE 1
QUICKSTART B 60 Warning These are only brief instructions! Please read and comply with these instructions prior to using or servicing your appliance. The non-compliance of the operating and safety instructions may lead to damages of the appliance and to dangers for the operator and other persons. Start up 1 A B A Unplug the charger from the mains. B Wind the mains cable around the cable holders. 2 A B A Open the lock of the fresh water reservoir.
PAGE 2
QUICKSTART Operation 2 A D 3 A B E C Driving A Turn the programme selector switch to position 1 "Transport mode". B First select the driving speed at the rotary knob. Drive forward C Press the driving lever to the front. Stop the machine: Release driving lever. Reverse drive D Press the driving lever to the rear. Stop the machine: Release driving lever. Stop E Release driving lever. Adjusting the brush contact pressure A Arrest the lever in the desired position.
PAGE 3
QUICKSTART Finish operation 1 A B C Turn off the appliance A Close the regulatory button for setting the water quantity. B Release driving lever. C Set the program selection switch to suction or vacuuming. D Briefly drive forward and suck of the remaining water. E Turn the program selection switch to "OFF". F Remove the Intelligent Key. D 2 A 3 A 4 A 5 A E F B Emptying the Dirt Water Reservoir 몇 Warning Please observe the local provisions regarding the wastewater treatment.
PAGE 4
1 A B A Remove the coarse dirt sieve from the wastewater reservoir and clean it. B Check the fluff filter, clean if required. 2 A B 몇 3 A 4 A 5 A monthly daily Maintenance and care Kärcher Customer Service QUICKSTART Warning Please observe the local provisions regarding the wastewater treatment. A Loosen the lid for emptying the fresh water - do not remove it fully. Drain water.
PAGE 5
QUICKSTART Troubleshooting 1 A B 2 A B D E 3 A B 4 A B D Appliance cannot be started A Stand-by. Plug in the Intelligent Key. Turn the program selection switch to the desired programme. B Battery depleted. Charge battery. C Insufficient vacuum performance A Clean the seals between dirt water reservoir and cover and check for tightness, replace if required. B Clean the vacuum lips on the vacuum bar, turn or replace if required. C Check suction hose for blockages; clean if required.
PAGE 6
QUICKSTART Troubleshooting 5 A 6 A Brushes do not turn A If over-current switch in the electronics system has been triggered, turn programme selection switch to "OFF". Afterwards, set it back to the desired programme. B Check the brushes for blockage due to foreign particles, remove them if found. B Do not add detergents A Increase the water volume to activate the dosing pump. B Check level of detergent solution in the fresh water tank; refill, if required. 5.964-272.