Operation Manual

– 12
Waste water tank is overfilled.
Illustration
until
Illustration
 Empty the waste water tank right away.
See Chapter "Cleaning the waste water tank".
Waste water tank does not fit properly in the appliance.
 Check whether the lid is fit securely on the waste
water tank.
See Chapter "Cleaning the waste water tank".
Separator is blocked.
 Remove lid from the waste water tank and clean
the separator.
See Chapter "Cleaning the waste water tank".
The filter net of the waste water tank separator was
damaged during cleaning.
 Renew separator.
Cleaning or disinfecting agents are not suitable for the
appliance or were dosed incorrectly.
 Only use detergents and care products approved
by the manufacturer.
See chapter "Detergents and care products".
 Follow the manufacturer's dosage instructions.
The initial moistening of the rollers was not used or was
not used long enough, meaning that the rollers are not
completely moistened (rollers therefore only clean par-
tially).
Illustration
 Completely moisten rollers.
ATTENTION
Do not remove the handle from the basic unit once it has
been assembled.
The handle may only be removed from the basic unit if
the unit is sent out for service purposes.
Illustration
See illustration at the end of the operating instructions
 Insert screwdriver at a 90 degree angle in the small
opening at the rear side of the handle and remove
handle.
ATTENTION
Please ensure that the connection cable between the
basic unit and the handle are not damaged.
Subject to technical modifications!
Appliance is leaking waste water.
Appliance leaves streaks behind on the floor
Removing the handle from the basic unit
Technical specifications
Power connection
Voltage 220-240 V
1~50-60 Hz
Protection class IPX4
Protective class II
Performance data
Intake performance 460 W
Roller revolutions per minute 500 rpm
Filling quantity
Fresh water tank 400 ml
Cleaning station 200 ml
Dimensions
Cable length 7.0 m
Weight (without cleaning liquids) 5.0 kg
Length 320 mm
Width 270 mm
Height 1220 mm
20 EN