K 2.50 M 5.
! Safety Notes Use of the unit as authorized Use this unit exclusively for non-industrial purposes –for cleaning machines, vehicles, buildings, tools, facades, terraces, garden implements, etc., with high-pressure water jet (if necessary with the addition of cleaning agents). –for cleaning vehicle engines only in locations equipped with an appropriate oil separator. –with accessories, replacement parts and cleaning agents authorized by Kärcher.
Contents Before first use of the unit read these operating instructions and act in accordance with them. Keep these operating instructions in a safe place for later use or for a subsequent owner.
Preparation Transport cart assembly Spray gun assembly Attach spray lance Screw on high-pressure hose Connect to water inlet Open water tap fully Plug in power plug For additional information see page 8 and following 4
Operation with high pressure Choose spray lance Unit switch on ”1” Release safety ratchet on handgun Press lever Caution: recoil Safety instructions 5
Operation with Detergent Adjust to low-pressure jet No detergent in high-pressure mode Suspend detergent suction hose... ....
Finishing the operation Unit switch to ”0” Unplug power plug Turn off water tap Press lever (to de-pressurise) Engage safety catch on handgun Care, storage Clean detergent filter Clean water filter Frost protection 7
Before first use Assembly (page 4) When unpacking check the contents. Inform your dealer of any damage in transportation. Connection requirements Electrical connection The voltage shown on the rating plate must match the supply voltage. The current source must be properly earthed. Only use splash-protected extension cable with a sufficient conductor cross-section (10 m: 3 x 1.5 mm², 30 m: 3 x 2.5 mm²) and unwind completely from the cable drum.
Switching off • Release the lever. During breaks in work and when leaving the unit secure it against inadvertent switching on by pressing the safety ratchet. Regulate operating pressure High operating pressure: twist spray lance in direction “ ”. Low operating pressure: twist spray lance in direction “ ”. Adding the cleaning agent • Draw the cleaning agent suction hose out of the housing to the required length. • Hang the cleaning agent suction hose in the cleaning agent container.
Cleaning agents Help with faults For trouble-free operation and for matching to the relevant cleaning task we recommend our Kärcher cleaning agents and care range. Please let us advise you or ask for information about them.
Technical Data Power supply Voltage (at 1~50 Hz) Connected load Supply fuses (time-lag) Safety class Service 230 - 240 V 1,3 kW 10 A 1 Water connection Supply temperature, max. Supply volume,min. (500 l/h) Supply pressure, max. (12 bar) 40 °C 8 l/min 1,2 MPa Performance data Operating pressure (85 bar) 8,5 MPa Max. permissible pump pressure (100 bar) 10 MPa Flow volume (300 l/h) 5 l/min Cleaning agent metering 0,3 l/min Recoil force of the handgun 10 N Unit vibrations 0.
2.880-296.0 5.037-137.0 6.390-871.0 4.775-389.0 6.363-198.0 6.362-498.0 5.332-464.0 A A 2.883-111.0 A 2.883-111.0 6.903-276.0 9.011-390.0 A 2.883-111.0 9.011-422.0 9.084-057.0 9.011-656.0 6.389-870.0 05/03 5.960-643.0 Karcher Pty Ltd 40 Koornang Road Scoresby 3179 Victoria, Australia Tel.
