Operation Manual

– 3
When you unpack the system, check that
everything is complete.
If there are any missing parts or you detect
any transport damage when unpacking,
please inform your dealer immediately.
Note: The front cover pages include pic-
tures of the appliance and its operation.
Please unfold these first.
Illustration
1 Motor casing
2 Carrying handle
3 Foam filter
4 Filter lock
5 Power cord with plug
6 Storage, power cord
7 Switch for suction (0 / I)
8 Switch for spraying (0 / I)
9 Release, fresh water reservoir
10 Fresh water tank
11 Container
12 Swivel casters
13 Connection for suction hose of the wet/
dry vacuum cleaner
14 Connection, spray hose
15 Spray/suction hose
16 Handle
17 Surrounding air separator
18 Spray lever
19 Lock key for spray mist
20 Lock lever
21 Spray / suction tubes 2 x 0.5 m
22 Storage for suction tubes and accesso-
ries
23 Wash nozzle for carpet cleaning, with
hard surface attachment
24 Wash hand nozzle for upholstery clean-
ing
Attachment for wet/dry vacuuming
25 Attachment for wet/dry vacuuming
26 Floor nozzle with hard surface insert
27 Crevice nozzle
28 Upholstery nozzle
29 Filter bag
Illustration
 Remove the fresh water reservoir.
Press the release and remove the tank.
Note: The motor casing can only be re-
moved if the fresh water reservoir was
removed first.
Illustration
 Remove the motor casing. For this,
fold the carrying handle forward to un-
latch the reservoir. Remove the acces-
sories and swivel casters from the
reservoir.
Illustration
 Turn the container, press in the swivel
casters in the openings at the base of
the container till the end-point.
Illustration
 Turn the motor casing around and at-
tach the foam filter to the filter basket.
 Insert the filter cover and turn to lock.
 Install the motor casing. Pull up on
the carrying handle to lock.
Illustration
 Install the fresh water reservoir. In-
sert the bottom part first and then press
toward the top on the motor compart-
ment to check if it is locked in.
Illustration
 Attach the suction hose and the spray
hose to the connectors on the appli-
ance.
Note: Press the suction hose tightly into
the connector to lock it into place.
Illustration
 Connect the spray/suction pipes and at-
tach to the handle. Center the locking
lever when attaching it, turn clockwise
to lock.
Start up
Description of the Appliance
Before Startup
14 EN