Operation Manual

– 5
Note: Possibly remaining water can
drip out, therefore you should place
these into the shower or bathtub.
 Remove the accessories and the fresh
water reservoir and unlatch the motor
casing.
 Remove the motor casing and empty
the reservoir.
– Always work from the light to the shade
(from the window to the door).
– Always work from the cleaned to the un-
cleaned surface.
– Rugs with jute backing can shrink if too
much water is used and can bleed col-
ours.
– Brush high-fiber rugs in the direction of
the weave after cleaning (using a fiber
brush or a scrubber).
– Water-proofing the fabric using Care
Tex RM 762 after the wet cleaning pre-
vents a quick resoiling of the textile sur-
face.
– Do not step on cleaned surfaces until
they have dried and do not place furni-
ture on them to avoid pressure spots or
rust stains.
 Turn on suction and spraying
(position I).
 Spray and simultaneously suction off
detergent solution in one work cycle.
 Switch off the spray switch and suction
off the remaining cleaning solution.
 After cleaning the carpets, reclean them
using clear, warm water and waterproof
if needed.
 Switch on sprayer (position I).
 Apply detergent solution and soak for
10 to 15 minutes (suction is switched
off).
 Clean the surface just like you would
with light/normal soiling.
 After cleaning the carpets, reclean them
using clear, warm water and waterproof
if needed.
 Rinse the spray tubes in the appliance
as follows:
Fill the detergent container with about 1
liter of clear water.
Hold the nozzle above the drain, and
switch on the spraying pump until the
clear water has been consumed.
몇 Caution
Always work with the filter bag inserted, ex-
cept when a cartridge filter is used (option).
The reservoir and accessories must be dry
to prevent parts from sticking together.
Illustration
 Insert a filter bag.
Illustration
 Use the adapter for wet/dry vacuuming
Attach the adapter to the handle, turn
the locking handle to secure it.
 Select the desired accessories and at-
tach to the spray/suction pipes or direct-
ly to the attachment.
 Switch on suction (position I).
Illustration
 Insert the hard surface inlay into the
floor nozzle. The bristles should point
towards the front.
Illustration
 Work without the hard surface insert.
 Use the surrounding air separator to
adapt the suction force.
Note: Close the surrounding air separa-
tor again after use!
Cleaning tips/mode of operation
Cleaning methods
Light/normal contamination
Heavy soiling or stains
End wet cleaning process
Dry vacuum cleaning
Vacuuming hard surfaces
Vacuuming carpeted floors
16 EN