Use and Care Manual

ManualsBrandsKarnak ManualsBuilding materials5 Gal. Perfectseal Fibered Aluminum Reflective Roof Coating

SECTION 1 - PRODUCT IDENTIFICATION

IDENTITY:

Aluminum Asphalt Coatings MANUFACTURER:

(Asbestos-Free)

# 27AF

Karnak Corporation

330 Central Ave.

Clark, NJ 07066 U.S.A.

DATE: 2/15/13

Rev. 3

Telephone #: 1-800-526-4236

24 HR CHEMTREC EMERGENCY NUMBER 1-800-424-9300 (OUTSIDE THE U.S AND CANADA 1-202-483-7616)

SECTION 2 - COMPOSITION, INFORMATION ON INGREDIENTS

Other Limits

Components CAS# Weight % OSHA PEL ACGIH TLV Recommended

Oxidized Asphalt 64742-93-4 35-55 5mg/m

0.5mg/m

5mg/m

(NIOSH)

Aliphatic Hydrocarbons 8052-41-3 35-55 100 ppm 100 ppm 350mg/m

(NIOSH)

(Stoddard)

Aromatic Petroleum Distillates

Aluminum Pigment

Amorphous Alumina Silicates

Cellulosic Fibers

Limestone

PEL = Permissible Exposure

Limits OSHA = Occupational Safety and Health Administration

TLV = Threshold Limit Value ACGIH = American Conference of Governmental Industrial Hygienists

N.E. = Not Established NIOSH = National Institute for Occupational Safety and Health

N/A = Not Applicable.

SECTION 3 - HAZARDS IDENTIFICATION

Combustible liquid and Vapor

Potential Health Effects:

Fumes from product can be unpleasant, may cause nausea, headache and irritating to eyes, skin, and respiratory tract.

Page: 1 of 5

64742-95-6

<10

100mg/m

(Exxon

7429-90-5

<25

15mg/m

10mg/m

93763-70-3

<10

15mg/m

10mg/m

9004-34-6

N/A

1317-65-3

<20

15mg/m

10mg/m

Summary of content (5 pages)

PAGE 1
Page: 1 of 5 SECTION 1 - PRODUCT IDENTIFICATION IDENTITY: Aluminum Asphalt Coatings (Asbestos-Free) # 27AF MANUFACTURER: Karnak Corporation 330 Central Ave. Clark, NJ 07066 U.S.A. DATE: 2/15/13 Rev. 3 Telephone #: 1-800-526-4236 24 HR CHEMTREC EMERGENCY NUMBER 1-800-424-9300 (OUTSIDE THE U.
PAGE 2
MSDS Page 2 of 5 Aluminum Coatings Rev 3 SECTION 4 - FIRST AID MEASURES Eye Contact: If this product comes in contact with eyes, Flush eye with plenty of water for at least 15 minutes and seek medical attention. Skin Contact: If this product comes in contact with skin, remove material with mineral oil, then wash with soap and plenty of water. Inhalation: If respiratory discomfort occurs, remove to fresh air. If discomfort continues, administer oxygen and get medical attention.
PAGE 3
MSDS Page 3 of 5 Aluminum Coatings Rev3 SECTION 7 - HANDLING AND STORAGE Vapors are heavier than air and may travel along the ground or be moved by ventilation to locations distant from the point of material handling. To prevent ignition, avoid smoking, keep away from heat, open flames and sources of static or electrical sparking. Use explosion proof motors and equipment. Tank trucks or other containers should be grounded and/or bonded when the material is transferred.
PAGE 4
MSDS Page 4 of 5 Aluminum Coatings Rev 3 SECTION 10 - STABILITY AND REACTIVITY Stability: Stable Conditions to Avoid: Keep away from heat, spark, open flames. Auto-ignition temperature unknown. Incompatibility (Materials to Avoid): May react with strong oxidizing materials. Hazardous Decomposition or Byproducts: Combustion: carbon dioxide (CO2), carbon monoxide (CO), nitrogen oxides, smoke, and fumes. Hazardous Polymerization: Will not occur.
PAGE 5
MSDS Page 5 of 5 Aluminum Coatings Rev 3 SECTION 14 - TRANSPORTATION INFORMATION The description shown may not apply to all shipping situations. Consult 49 CFR, or appropriate regulations, for additional description requirements.