SDS

Clarion® Food Grade White Mineral Oil 90
White mineral oil, petroleum
ACGIH TLV (United States, 2/2010).
TWA: 5 mg/m³ 8 hours. Form: Inhalable fraction
NIOSH REL (United States, 6/2009).
TWA: 5 mg/m³ 10 hours. Form: Mist
STEL: 10 mg/m³ 15 minutes. Form: Mist
OSHA PEL (United States, 6/2010).
TWA: 5 mg/m³ 8 hours.
White mineral oil, petroleum
ACGIH TLV (United States, 2/2010).
TWA: 5 mg/m³ 8 hours. Form: Inhalable fraction
NIOSH REL (United States, 6/2009).
TWA: 5 mg/m³ 10 hours. Form: Mist
STEL: 10 mg/m³ 15 minutes. Form: Mist
OSHA PEL (United States, 6/2010).
TWA: 5 mg/m³ 8 hours.
8. Exposure controls/personal protection
Use a properly fitted, air-purifying or supplied-air respirator complying with an approved
standard if a risk assessment indicates this is necessary. Respirator selection must be
based on known or anticipated exposure levels, the hazards of the product and the safe
working limits of the selected respirator.
Safety eyewear complying with an approved standard should be used when a risk
assessment indicates this is necessary to avoid exposure to liquid splashes, mists or
dusts. If contact is possible, the following protection should be worn, unless the
assessment indicates a higher degree of protection: safety glasses with side-shields.
Personal protective equipment for the body should be selected based on the task being
performed and the risks involved and should be approved by a specialist before
handling this product.
Personal protection
Eyes
Skin
Respiratory
:
:
:
Chemical-resistant gloves complying with an approved standard should be worn at all
times when handling chemical products if a risk assessment indicates this is necessary.
Considering the parameters specified by the glove manufacturer, check during use that
the gloves are still retaining their protective properties. It should be noted that the time
to breakthrough for any glove material may be different for different glove
manufacturers. In the case of mixtures, consisting of several substances, the protection
time of the gloves cannot be accurately estimated.
Hands
:
Engineering measures
:
Good general ventilation should be sufficient to control worker exposure to airborne
contaminants.
Hygiene measures
:
Wash hands, forearms and face thoroughly after handling chemical products, before
eating, smoking and using the lavatory and at the end of the working period.
Appropriate techniques should be used to remove potentially contaminated clothing.
Wash contaminated clothing before reusing. Ensure that eyewash stations and safety
showers are close to the workstation location.
Recommended monitoring
procedures
:
If this product contains ingredients with exposure limits, personal, workplace
atmosphere or biological monitoring may be required to determine the effectiveness of
the ventilation or other control measures and/or the necessity to use respiratory
protective equipment. Reference should be made to appropriate monitoring standards.
Reference to national guidance documents for methods for the determination of
hazardous substances will also be required.
Environmental exposure
controls
:
Emissions from ventilation or work process equipment should be checked to ensure
they comply with the requirements of environmental protection legislation. In some
cases, vapor controls, filters or engineering modifications to the process equipment will
be necessary to reduce emissions to acceptable levels.
Ingredient
Exposure limits
Personal protective equipment should be selected based upon the conditions under which this material is used. A hazard
assessment of the work area for PPE requirements should be conducted by a qualified professional.
4/8
633509009
3/28/2014.