Owner's manual

7
To use this nozzle, you must have the upper
pump housing in place. This nozzle has fl ared
outer fi ns and the number 1 molded on top
portion of the nozzle. Comes installed on unit.
Condor:
Produces a two-tiered arch of water with an
inner arch 4 feet high by 4 feet in diameter and
an outer arch 2 feet high by 10 feet in diam-
eter.
To use this nozzle, you must have the upper
pump housing in place. This nozzle has fl ared
outer fi ns and has the number 2 molded on the
top of the nozzle.
Falcon:
Produces a narrow arch of water 4 feet high by
4 feet in diameter.
To use this nozzle, you must have the upper
pump housing in place. This nozzle has nearly
vertical outer fi ns and the number 3 molded on
the top of the nozzle.
STEP NINE
Set C-25 Timer to desired ON and OFF times
per the C-25 Instructions on page 8. Make
sure to test the GFI using the Test Button
located on the outlet before turning the equip-
ment on and every 30 days thereafter. Plug
the 1400JF cord into the C-25 outlet labeled
“UNIT”. If lights are included, plug the
Transformer cord into the C-25 outlet labeled
“LIGHT”.
STEP TEN
Plug the C-25 into the 120V power supply
on post and ENJOY YOUR NEW KASCO
1400JF AERATING FOUNTAIN.
Options & Pattern Sizes
The unique center set design of Kasco’s
1400JF Aerating Fountain nozzles offers the
best clog-resistance and interchangeability
available. To achieve the pattern you desire,
simply select the appropriate nozzle according
to the accompanying photos and install using
the proper bolt or screw into the fountain tube
or upper pump housing (depending on which
nozzle chosen). Be sure to snug the bolt or
screw to ensure the correct pattern display and
size.
NOTE: Pattern sizes listed are approximate.
Variations in voltage caused by regional elec-
trical differences or voltage drop due to long
power cords may result in reduced pattern
sizes.
Osprey:
Produces a wide arch of water 3.5 feet high by
7 feet in diameter.