Product Manual
10
Circulator Tools & Supplies Needed
A. Anchors or stakes for installing unit (2)
B. 120V or 240V Electrical Supply near pond on a
post (1)
C. 12” pieces of 1” galvanized pipe for weighting
ropes (optional) (2)
D. 9/16” (14mm) & 7/16” (11mm) Nut Driver
E. 9/16” (14mm) & 7/16” (11mm) Socket
F. Adjustable crescent wrench
G. 7/16” Wrench (1)
H. 7/16” Socket & Wrench (1)
I. Felt-tip marker (1)
Circulator (CF Model) Assembly
STEP ONE
Remove all contents from package and place on a clean,
at surface. Inspect the shipment for any damages. Make
sure you have all the parts needed.
STEP TWO
Position the Float (Part B1)upside down (lengthwise chan-
nels facing up) and place the Base Strap (Part B2) so the
three holes in the Base Strap align with the three threaded
holes that comprise the lengthwise midline of the Float.
STEP THREE
Position the Adjustment Bracket (Part B3) over the two
holes at the back end of the Float and Base Strap. Loosely
secure the Adjustment Bracket to the Float using two 1/4” x
1/2” (Part B8) Stainless Steel Bolts and two Stainless Steel
Lock Washers (Part B13). (See photo above for orienta-
tion.)
STEP FOUR
Place one of the three Angle Brackets (Part B4)perpendicu-
STEP TWO (ALTERNATE INSTALLATION)
In ponds where the water level uctuates signicantly, you
may need to suspend a small weight (12” of 1” galvanize
pipe works well) at the mid-point of the rope to take up any
slack as the water level drops. The weight should be light
enough so the Aerator can rise as the water level rises. This
can also help hide ropes by sinking them further below the
surface.
Normal Water level
Power Cord
Anchor Rope
Secondary Weight
Low Water Level
Kasco Power
Control Box
High Water Level
STEP THREE
At this time the Aerator is ready for operation. It can
be plugged into the power supply at the pond edge.
ENJOY YOUR NEW KASCO EQUIPMENT!
Circulator Parts (CF Models)
Circulator (Unit with cord or stub cord) (1)
Float in separate box (1)
# Item Part # Qty
1
Float
213002 1
2
Base Strap
413006 1
3
Adjustment Bracket
413005 1
4
Angle Bracket
413001 3
5
Draw Band
413004 1
6
U-Bracket
413002 2
7
Spacer Bracket
413003 2
8
1/4” x 1/2” Stainless Steel Bolt
451126 8
9
1/4” x 1” Stainless Steel Bolt
451130 3
10
1/4” x 1-3/8” Stainless Steel Bolt
584692 2
11
1/4” Stainless Steel Lock Nut
451100 8
12
1/4” Stainless Steel Hex Nut
840536 2
13
1/4” Stainless Steel Lock Washer
840537 5
14
50’ Black Nylon Ropes
990700 2
15
Nylon Cable tie
415038 1
16
Draw strap retaining ring
997155 1